Évaluations - 0, GPA: 0
(
)
)
|
Facilité d'utilisation
Crevice nozzle 16. Brush for wooden floor 17. Dust bag holder 18. Dust bag 19. Motor protection filter IMPORTANT ADVICE • Read these instructions carefully. Safeguard them for future reference. • This appliance has been designed exclusively for domestic use. It must only be used in accordance with these instructions. The manufacturer will not be held any responsibility for any damage caused by improper use or incorrect operation. • Do not use the vacuum cleaner on people or animals. • Never vacuum up hot or glowing substances, sharp-edged objects and inflammable or explosive substances. • Do not let children handle the appliance. • Do not expose the vacuum cleaner to outdoor weather conditions, dampness or heat. Do not leave the vacuum cleaner beside hot ovens, heaters or radiators. • Before plugging the appliance into the mains supply, make sure that the voltage corresponds to that stated on the characteristics plate. • The appliance must be switched off before plugging it in or unplugging it. • Do not operate the appliance with the cable still coiled. • Do not unplug the appliance by tugging on the cable. • Unplug the vacuum cleaner from the mains supply when not in use and before proceeding to clean it or change the bags or filters. • This vacuum cleaner must not be used without the dust bag and filters. This could damage the appliance. • Do not use the vacuum cleaner if any of its openings are obstructed, as this will reduce the air flow causing it to overheat, which may damage the appliance. • Do not handle either the vacuum or the plug with wet hands. Do not immerse the appliance in water. • Do not pull on either the cable or the suction tube to move the vacuum cleaner. Use the carrying handle. • Do not use the appliance if either the cable or plug is damaged or if it can be detected that the appliance is not working correctly. • When closing doors, make sure not to pinch the cable. • This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or lack or experience and knowledge, unless they have been given supervision or instruction concerning use of the appliance by a person responsible for their safety. • Children should be supervised to ensure that they do not play with the appliance. • At the end of its life, the vacuum cleaner should be disposed of in an appropriate manner. • Cable repairs and replacements must be carried out exclusively by an authorized technical service centre. • ATTENTION: Do not use the vacuum cleaner to suck up building waste (cement, brick dust, rubble, etc.). These types of particles quickly clog up the pores in the dust bag causing the appliance to overheat. SWITCHING ON AND OPERATION -Insert the hose (3) into the suction hole (5) so that it clicks into position. Pressing down the release button will help you to insert or remove the hose (3). (Fig. 1) -Attach the telescopic tube (2) to the suction hose (3), and adjust the length to suit the user. (Fig. 2) - Fit the floor brush (1), or whichever accessory is required, to the vacuum tube. (Fig. 3) -Holding the power cord by the plug, pull out the required length and plug it into the mains socket. (Fig. 4) -Press the On/Off pedal (6), (Fig. 5). Regulate the power using the power regulator (7), slide the regulator right and left to achieve your desired power (Fig. 6). The intensity can be regulated from the handgrip. Opening the flap (4) reduces suction, whereas closing it increases suction. (Fig. 7) -You can use the parking aid on the back of the vacuum cleaner if you wish to stop vacuuming for a short while. Slide the catch on the brush into the groove at the rear of the appliance (Fig. 8) or clip the tube onto the vacuum cleaner at vertical positon. (Fig. 9) -The wheels and 360° swivel joint and the carrying handle, make this vacuum cleaner extremely mobile. WHEN FINISHED When you have finished using the appliance, set the power regulator (7) to the minimum position and press the On/Off button. Press the automatic cable rewind pedal (8) to wind the cable back in. (Fig. 10) REPLACING AND MAINTAINING Container full indicator (9) When suction power decreases considerably and a red marker is moved into a window mounted on the top of the vacuum cleaner. This means that the dust bag (18) is full or that the hose or filters are blocked. If this occurs, follow the instructions for changing the dust bag (18) and cleaning the filters. Changing the dust bag -Open the cover by pressing down the release button. (Fig. 11) -Take the dust bag together with the bag holder (17) out of the appliance. (Fig. 12) -Remove the dust bag from the holder (Fig. 13). Close the bag by pulling on the central flap. (Fig. 14) - To fit a new bag, fold the flap back (Fig. 15). Insert the bag into the bag holder, following the direction of the guide-arrow. Make sure that it slots fully down into its housing and that it fits correctly. Close the cover. Important: • There is a dust bag absence ...