Évaluations - 3, GPA: 3.7
(
)
)
|
Facilité d'utilisation
As this could result in an increased risk of fire or damage to your cooker. • Don't use the cooker with glass windows removed. Don't use the cooker for • Hanging towels and dish cloths etc on the handles. • Warming plates under the grill. • Heating the kitchen. • Drying. • Always refer servicing to a qualified appliance service engineer. Food hygiene • Ensure meat and poultry is thoroughly defrosted before cooking. • Check food is thoroughly cooked and is piping hot. 5 know your cooker 1.0 kW hot plate 2.0 kW hot plate with rapid heating element Control panel Grill Grill door Oven door specification Packed external dimensions H: 985 mm W: 560 mm _D: 700 mm Because we continually strive to improve our products, we may change our specifications and designs without prior notice. Accuracy Note that times and temperatures in this book are for guidance only. (*) protector Supply voltage 230V AC Supply frequency 50 Hz Maximum wattage 10.4 W Adjustable grill wattage 2000 W Oven wattage 2400 W Hotplate wattage - Front left 2000 W (*) Hotplate wattage - Rear left 1000 W Hotplate wattage - Front right 1500 W (*) Hotplate wattage - Rear right 1500 W (*) Unpacked external dimensionsH: 900 mm W: 500 mm D: 600 mm Hob Integral air grill BSKD ,.v.:s a a Sa 1.5 kW hotplate 1.5 kW hotplate with rapid heating element Grill switch button This prevents the grill from operating when the door is closed Shelf runners Oven tray Rating label Some of the illustrated details may vary 6 electrical connection • Do not connect the cooker to the electricity supply until all packing and transit protectors have been removed. 1 Before your appliance is connected to the mains electricity supply, check to ensure that the voltage and frequency shown on the rating label corresponds with your power supply. The label is located on the plinth below the oven door. q 2 This product must only be installed by a qualified electrician eg local '¿I# electricity company or NICEIC registered contractor to a suitable double-pole control unit with a minimum contact clearance of 3mm in all poles and with a minimum rating of 32A which should be fitted adjacent to (but not above) the cooker in accordance with IEE regulations. Failure to observe this instruction may result in operational problems and invalidation of the product warranty. 3 Access to the mains terminal is gained by removing the small rear cover. The cable must have conductors of sufficiently high cross sectional area to prevent overheating and deterioration. Recommended cross-section area is six square f millimetres (6.00 mm2). The mains cable must conform to BS6004. This appliance must be earthed. 4 The mains cable must pass through the cable clamp. 5 The mains cable should be routed away from the appliance and in particular ventilation slots, the vent outlet and should not be obstructed when pushed in to position between the appliance and the wall and/or cabinets. • The appliance conforms to BS 800: 1988 and EEC directive 87/308 regarding suppression of radio and television interference. • Type with regard to protection against overheating of surrounding surfaces=X. location • Excess steam from the oven is expelled at the rear of the appliance therefore the wall behind the cooker needs to be protected against grease and moisture. • The cooker is designed to fit between kitchen cabinets spaced over 500 mm apart. The space either side of the cooker need only be sufficient to allow withdrawal of the cooker for servicing. It can be used with cabinets on one side or both sides as well as in a corner setting. It can also be used free-standing. • Adjacent side walls above the appliance must not be nearer to the cooker than 150mm and should be of heat resistant material. Leave at least 750 mm clearance above the hob. To avoid damage to surrounding units a 10mm gap should le left between the appliance and the units. If this is not possible, a kit ( part number 01 25552 00) may be ordered from Customer Care which will protect the units. For models with side opening doors, we recommend a side clearance of 60 mm betwen the cooker and any side wall to allow the door to be opened fully. 7 installation Levelling The appliance should be located on a level surface. The two front feet can be adjusted as required. To ensure that your appliance is standing level adjust the two front feet by turning clockwise or anticlockwise until the product is in firm contact with the floor. preparation and burning off ffi| Important for asthmatic • sufferers Before using for the first time, protective coatings need to be burnt off. Fumes will be emitted but this is quite normal. Ensure the room is very well ventilated during the burning off process. Avoid directly inhaling the fumes during this process. Hotplates Adjust the hotplates to the mid position and leave on for about 8 minutes. Do not place any pans or other cooking utensil on the hotpla...