Évaluations - 3, GPA: 3.7
(
)
)
|
Facilité d'utilisation
Doing so may result in a burst of flame that could cause burns or damage to the surrounding area. • Do not touch any part of a burner while the igniter is sparking. An electrical shock may result. • Never move the outdoor grill when cooking or when it is hot. Always keep the canopy closed when moving the grill cart. • Spiders and insects can nest in the burners of this outdoor grill. This can obstruct the proper flow of gas into the burner and cause improper operation, fire hazard and potential damage to the unit. Periodically inspect the burners. If any of these symptoms occur, immediately refer to service or the Before You Call for Service section of this manual. • If any burner flames are blown out by wind and do not automatically re-ignite within five seconds, turn the knob to off and wait five minutes for the gas to dissipate. Attempt a new ignition until you hear the constant clicking stop and you see flame ignition. • Do not leave the canopy open when the outdoor grill is not in use to prevent an accumulation of water/ moisture inside. If water accumulates in the grill compartment the unit should not be used and a service technician should be called to clean the inside of the compartment. • If the appliance is left out in the rain (with the canopy shut), wait until 30 minutes after the rain storm ends before using it. BLO W BACK HAZAR D IN COL D WEAT HER • - If lighting the rotisserie or optional sear burner in very cold weather, “blow back” may occur. After lighting, if you hear a whooshing sound, immediately turn the burner control knob off. Wait several minutes before trying to light the burner again. Lighting and Preheating - Grill Compartment M 1. ake sure the drip tray is in place. 2. Open the canopy to the fully open position. 3. If using a LP tank, make sure all control knobs are in the OFF position, then turn the valve on the top of the tank counter- clockwise to the fully open position. 4. Light one burner at a time. Push in on the knob for the burner you want to light and turn it counter-clockwise to the LIGHT/HIGH position. See the facing page for knob locations. The burner igniter will spark repeatedly until it lights. The spark makes a “clicking” sound. The burner should light within five seconds. If the burner does not ignite in five seconds, turn the burner knob to the OFF position. Keep the canopy open. Wait five minutes. Repeat the lighting procedure. If a burner does not ignite after three tries, you may light it manually (see page 12). Also see the Before You Call for Service section on page 23. 5. Light all of the remaining burners (including the sear burner if equipped) in the grill compartment. imp ortant • Lighting all of the burners and preheating the grill compartment helps keep the components clean and makes them hot enough to vaporize juices that drip through the grate. Without a proper preheat, a residue will build on the components decreasing burner performance and causing ignitor malfunction. F • or outdoor grills equipped with the optional sear burner, see page 16 for sear burner use instructions. • Light the rotisserie burner only if you will be performing rotisserie cooking. See page 13 for more information. 6. After the burners are lit, close the canopy and preheat with all burners on HIGH until the temperature gauge indicates the desired grilling temperature for the food being cooked. Normal cooking temperature varies between 225 to 500.F (110 to 260.C). 7. Turn the burner knobs further counter-clockwise to lower the flame and maintain the desired temperature. Preheat for five minutes more before cooking. 8. During cooking, check the food periodically using the temperature information on the Safe Cooking Temperature Chart on page 16. Check the internal meat temperature with a meat thermometer to determine doneness. The outdoor grill cooks more rapidly with the canopy shut, slower with it open. OFF LIG HT/HIG H 11 Operating Your Outdoor Grill Lighting the Side Burners (OB52, OBS52 and OBSB162 Only) Each side burner control knob has an icon next to it to tell you which burner it operates. 1. Push in on the knob and turn it counter-clockwise to the LIGHT/HIGH position. The knob will illuminate and the igniter for the burner will spark (click) repeatedly until it lights. The burner should light within five seconds. 2. If the gas does not ignite after five seconds or if the flame goes out and gas escapes, turn the knob to the OFF position. Allow at least five minutes for the gas to dissipate. R 3. epeat the lighting procedure. If a burner still does not ignite, the igniter continues to spark or if the flame is not spread evenly around the burner cap, see the Before You Call for Service section on page 23. The burner(s) may also be light manually (see page 12). 4. Place the cooking utensil on the grate. 5. Turn the control knob counter-clockwise to reduce the flame until it covers approximately 1/3 of the utensil diameter. Doing so will ensure even heating and reduce the...
Ce manuel est également adapté pour les modèles :Greeley - DACOR OB52 (6.02 mb)
Greeley - DACOR OB36 (6.02 mb)
Greeley - DACOR OBS36 (6.02 mb)
Greeley - DACOR OBSB162 (6.02 mb)