Log:
Évaluations - 3, GPA: 4.3 ( )

Instructions Alphasonik, Modèle PFZ693E

Fabricant : Alphasonik
Taille : 1.91 mb
Nom Fichier :
Langue d'enseignement: en
Aller à la télécharger



Facilité d'utilisation


If you allow an insufficient amount of air space, the speaker may not reproduce low frequencies very well. It is recommended to mount the speakers in door panels, kick panels, rear decks, etc. Ideally, the speaker should be mounted where it will be in an enclosed airspace, allowing for extended bass response. NOTE: Alphasonik strongly recommends that you operate your system at low volumes prior to the completed installation of your Alphasonik speakers. This will allow a test of the speaker before securing it to its permanent location. CAUTION: Make sure that all speaker wiring is fully protected from cuts, tears and possible wear. Any short circuit developing as a result could severely damage the source unit or possibly the amplifier. Make sure all speaker wires easily reach the speaker terminal with no stress on the wires or connectors. MOUNTING: 1: Confirm the mounting location and depth requirements by inspecting the area where the speaker will be mounted. Most speakers will fit into stock locations on the vehicle, in this case only depth is important. 2: If the location you have picked does require cutting, you may use the supplied template to help you locate and mark the mounting location and cuts to be made. Be careful when cutting out the template. If you cut the template properly, the speaker will be a perfect fit. 3. If there is a cosmetic panel where the speaker will be mounted, we recommend using a utility knife to carefully cut a hole in it. Confirm the cut by placing the speaker in the hole. You may modify the hole as necessary. 4. If it will be necessary to cut steel, reinstall the cosmetic panel in place and use the hole you have previously cut as a template. This will help to insure proper cutting and a good fit. Mark the location for the speaker mounting screws, remove the panel and drill the screw holes. When finished you may replace the panel. 5. After cutting and drilling all holes, inspect the mounting areas for any metal burrs or rough edges. File any area that may interfere with the mounting of the speaker. 6. Clean any metal shavings from the mounting area and check for areas in which water may enter the speaker cavity. Treat the 6 I N S T A L L A T I O N I N S T A L L A T I O N C O N T I N U E D 7I N S T A L L A T I O N C O N T I N U E D 7 Make sure your source unit (Cassette, CD, DAT, DVD, etc) is turned off while connecting the speaker terminals. Turn on the various components and slowly advance the volume. Remember to check and recheck all connections to insure proper use. 1. Alphasonik recommends using at least 18-gauge wire with your new speaker system. Thinner gauge wire may easily be severed and can cause damage to your system should any bare wire come in contact with the vehicle's chassis. 2. Make sure that your audio system is off while installing and connecting your new Alphasonik speakers. Failure to do so could result in damaging the speaker beyond repair. 3. Be sure to route the wires to the speakers with the...

Ce manuel est également adapté pour les modèles :
Haut-parleurs - PFZ325E (1.91 mb)
Haut-parleurs - PFZ400E (1.91 mb)
Haut-parleurs - PFZ410E (1.91 mb)
Haut-parleurs - PFZ460E (1.91 mb)

Écrivez votre propre critique du dispositif



Texte du message
Votre nom :
Entrez les deux chiffres :
capcha





catégories