|
Facilité d'utilisation
Use only industry approved mounting methods and hardware. Califone cannot be responsible for improper installation or subsequent damage. 2 3 4 5 6 4 DC In jack (2) 1/4” microphone jack Audio line-out with variable volume control Audio line-in RCA jacks (2) Volume on/off and volume control Tone control Audio line-out with fixed volume control 1 2 3 4 5 6 7 7 2 1 3 PI30-SP NON-POWERED FIELD ARRAY SPEAKER SPECIFICATIONS Clamping of any PI30/PI39 Series Field Array Speaker WARNING Improper installation can cause serious injury. Use only industry approved mounting methods and hardware. Califone cannot be responsible for improper installation or subsequent damage. 1 Spring-loaded terminals 1 4 Setup and Operation for Powered Array Speakers (PI39 and PI30-PS) Power Plug the power adapter into a standard AC outlet and the DC plug into either of the DC jacks on the rear of the speaker. Microphone For use with a cabled microphone, plug the mic into one of the 1/4” phone jacks before turning on the power. Turn the power ON (the red LED will light) and adjust the volume to the desired level while speaking into the microphone. Line-In Two pair of RCA jacks are provided to connect audio from CD, LCD Projector or other audio sources. The Left and Right channels are “summed” because the speaker system is monaural. Fixed and Variable Line Outs Both the PI39 and PI30-PS have fixed and variable volume line out features. With these two features, you can not only daisy chain additional speakers for wider audio distribution, but also support functioning of an independent system (supporting special needs students for example.) Both line outputs are the same audio mix as what’s being output by the speaker itself. Which output is used depends on where you prefer to control the volume from. Fixed The fixed line output level is not affected by the main volume control. Variable The variable line output level varies with the volume control setting. Tone Control The tone control would normally be set at 12 o’clock and will have little effect when using a microphone. When playing music turning the control clockwise will increase the treble, while turning counter clockwise will increase the bass. LED Indicators There are two LED indicators behind the speaker grille. Red indicates that there is a UHF transmission signal from the microphone. The green lights when audio is being transmitted. PI39 16-Channel UHF Powered Speaker Only The PI39 can receive wireless audio from any 900MHz Califone UHF transmitter (PA919SD, PA919, and wireless mics). Wireless Receiver If using a Califone wireless transmitter, first make sure the transmitter and PI39 speaker are set to the same frequency. Turn on the receiver power and adjust the volume to 10 o’clock. Then turn the speaker power and adjust the volume level to 10 o’clock. Wireless Microphones There are two wireless microphone transmitters for use with the PI39; Q319 handheld microphone and M319 beltpack transmitter used with your choice of...
Ce manuel est également adapté pour les modèles :Haut-parleurs - PI30 Series (463.75 kb)
Haut-parleurs - PI30 Series (463.75 kb)
Haut-parleurs - PI39 Series (463.75 kb)