Évaluations - 4, GPA: 4
(
)
)
|
Facilité d'utilisation
OFF SLOPE CROSSOVER 12dB 24dB 60Hz 200Hz MAX REVERSE 0 7890123456 1POWER switch Press to switch the power to the Subwoofer ON/OFF. 2ON/STANDBY indicator Lights up according to the operation modes of this unit as de scribed below. Green ................ Power ON (Operating status) Red .................... Standby mode initiated by remote control Amber ............... Standby mode initiated by Auto Shut-off func tion Extinguished .... Power OFF or power supply failure Auto Shut-off. The Subwoofer automatically returns to STANDBY mode (amber light) when no signal has been input for about 8 minutes. When standby is initiated by Auto Shut-off: The subwoofer returns to the power ON status (operating status) in a few seconds when a signal is input or when the power key of the remote control unit is pressed. 3Remote control sensor Receives the transmission from the remote control unit. 4PEAK INDICATOR indicator The brightness of this indicator varies according to the amplitude of the low-frequency component in the input signal. The PEAK INDICATOR indicator lights very brightly when the built- in amplifier of the Subwoofer is overdriven. If the Subwoofer is used in this condition, the sound is distorted and the Subwoofer itself may also fail. To prevent this, reduce the volume of the Subwoofer or adjust the amplifier or receiver in order to reduce the input signal to the Subwoofer. 5MODE select key This key selects the sound mode of the Subwoofer. The Subwoofer incorporates the music and movie modes which can provide optimum deep-bass reproduction characteristics for the music source and movie audio respectively. Each press switches the mode as follows. When MUSIC indicator lights ................. music mode When CINEMA indicator lights .............. movie mode 6PHASE select key @ Each press of this key switches the phase of the sound output from the Subwoofer. When NORMAL indicator lights ...... Normal phase When REVERSE indicator lights...... Reverse phase - = ~ 7MUSIC indicator 8NORMAL indicator 9REVERSE indicator 0CINEMA indicator -VOLUME CONTROL knob @ Adjusts the volume level of the output of the Subwoofer. Rotating the knob clockwise increases the volume level, and rotating the knob counterclockwise decreases the volume level. =SLOPE selector switch @ This switch selects the attenuation characteristic of the sound output from the Subwoofer. ~CROSSOVER control knob @ Turn the control knob to adjust the cutoff frequency of the high- frequency components in the sound output from the Subwoofer. Standby mode While the standby indicator of the unit is lit in red or amber, a small amount of current is flowing into the unit’s internal circuitry to back up the memory. This condition is referred to as the standby mode of the unit. While the unit is in the standby mode, it can be turned ON from the remote control unit. Caution concerning operation An excessive input level to the Subwoofer may impair the sound quality or damage the unit. Careful attention should therefore be paid to the following precautions. 1. Do not increase the output of the amplifier to a high level while the low-frequency level is enhanced by the amplifier’s tone control or loudness control. 2. When operating the amplifier switches or when placing the stylus on an analog record, set the amplifier volume to its minimum level. Remote control operation How to operate Operation range 6 m 30°30° Remote control sensor on the Subwoofer POWER VOLUMEPHASE MUSIC/CINEMA REMOTE CONTROL UNIT RC-W0502 1 2 4 3 Model : RC-W0502 Infrared ray system Plug in the power supply plug of the Subwoofer to the AC outlet and press the POWER switch on the Subwoofer to turn ON. When power is ON : Remote control operation is immediately available. In Standby mode : First press the POWER key of the remote control unit to ON, then press the desired key. SW-505D (EN) 1 POWER key Press to switch the power ON/STANDBY when the POWER switch of the Subwoofer set to ON. 2 MUSIC/CINEMA select key 0 This key has the same function as the MODE key on the Subwoofer. When MUSIC indicator lights ................. music mode When CINEMA indicator lights .............. movie mode 3 PHASE select key 0 This key has the same function as the PHASE select key on the Subwoofer. When NORMAL indicator lights ...... Normal phase When REVERSE indicator lights...... Reverse phase 4 VOLUME control keys 0 OThis keys have the same function as the VOLUME CONTROL knob on the Subwoofer. Loading batteries 1. Remove the back cover. 2. Insert batteries. 3. Close the back cover. Open by pushing the position Insert two R03 (”AAA”-size) batteries marked with the arrow. according to the polarity indication. NotesNotesNotes 1. The batteries initially supplied are intended for use in checking the remote control operations, so their service life may be shorter than usual. When the remote controllable distance shortens or remote control becomes impossible, replace both of the batteries with new ones. 2. Malfunction may o...
Ce manuel est également adapté pour les modèles :Haut-parleurs - SW-305 (827.72 kb)