|
Instructions Pioneer, Modèle S-ESR2TB
Aller à la télécharger
Par ce dispositif a également d'autres instructions :
Facilité d'utilisation
After connecting the plugs, pull lightly on the cords to make sure that the ends of the cords are securely connected to the terminals. Poor connections can create noise and interruptions in the sound. Surround left Surround right Center Front left Listening position Front right Subwoofer (not supplied) Center speaker Surround speakers CAUTION These speaker terminals carry HAZARDOUS LIVE voltage. To prevent the risk of electric shock when connecting or disconnecting the speaker cables, disconnect the power cord before touching any uninsulated parts. D3-4-2-2-3_A1_En Amplifier Speakers Striped half of speaker cord Other half of speaker cord Black Red WALL-MOUNTING THE SURROUND SPEAKERS Before mounting • Remember that the speaker system is heavy and that its weight could cause the screws to work loose, or the wall material to fail to support it, resulting in the speaker falling. Make sure that the wall you intend to mount the speakers on is strong enough to support them. Do not mount on plywood or soft surface walls. • Mounting screws are not supplied. Use screws suitable for the wall material and support the weight of the speaker. 3.7 mm 9.3 mm Mounting screw(not supplied) 5 mm to 7 mm • If you are unsure of the quality and strength of the walls, consult a professional for advice. • Pioneer is not responsible for any accidents or damage that result from improper installation. CABINET MAINTENANCE Use a polishing cloth or dry cloth to wipe off dust and dirt. When the cabinet is very dirty, clean with a soft cloth dipped in some neutral cleanser diluted five or six times with water, and then wipe again with a dry cloth. Do not use furniture wax or cleaners. Never use thinners, benzine, insecticide sprays and other chemicals on or near the cabinets, since these will corrode the surfaces. ATTACHING / DETATCHING THE GRILLE The front grille of this speaker system is removable. Proceed as follows: 1. To detatch the grille, grab it by its bottom with both hands and toward you to separate the bottom part of the grille from the speaker. 2. Next, grab the top part of the grille and gently pull it toward you to remove the top portion. 3. To replace the grille, align the holes in the front of the speaker’s corners with the projections on the grille, and push each of the corners into place. TROUBLESHOOTING Symptom Possible cause Remedy No sound • Bad speaker cord or connection. • Amplifier is off. • Connect correctly or replace cord. • Turn on amplifier. • Volume control is at zero. • Slowly turn up volume. Sound is distorted. • Extreme signal condition. • Turn down the amplifier’s output level (volume, bass control, bass boost) to lower the level. En SPECIFICATIONS SURROUND SPEAKERS Enclosure . . . . . . . . . . . . . . . . . . . Bass-reflex bookshelf type Configuration . . . . . . . . . . . . . . . . . . . . . . . . . . . ..10 cm 1-way Speakers . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 10 cm cone x1 Impedance . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .8 . Frequency response . . . . . . . . . . . . . . . . . . . . .50 Hz to 20 kHz Sensitivity (1m, 1W) . . . . . . . . . . . . . . . . . . . . . . . . . . . 81.5 dB Maximum input power . . . . . . . . . . . . . . . . . . . . . . . . . . 120 W Exterior dimensions . . . . . . . . . . . . . . . . 180 (W) mm x 130 (H) mm x 162 (D) mm Weight . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .1.3 kg CENTER SPEAKER Enclosure . . . . . . . . . . . . . . . . . . . Bass-reflex bookshelf type (magnetically shielded) Configuration . . . . . . . . . . . . . . . . . . . . . . . . . . . ..10 cm 1-way Speakers . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 10 cm cone x2 Impedance . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .8 . Frequency response . . . . . . . . . . . . . . . . . . . . .50 Hz to 20 kHz Sensitivity (1m, 1W) . . . . . . . . . . . . . . . . . . . . . . . . . . . 88.0 dB Maximum input power . . . . . . . . . . . . . . . . . . . . . . . . . . 120 W Exterior dimensions . . . . . . . . . . . . . . . . 350 (W) mm x 130 (H) mm x 162 (D) mm Weight . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .2.5 kg SUPPLIED ACCESSORIES Speaker cords . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .3 Non-skid pads . . . . . . . . . . . . . . . . . . . . . 12 (4 pcs x 3 sheets) Operating instructions Specifications and design subject to possible modification without notice due to improvements. © 2011 PIONEER CORPORATION. All rights reserved. If you want to dispose this product, do not mix it with general household waste. There is a separate collection system for used electronic products in accordance with legislation that requires proper treatment, recovery and recycling. Private households in the member states of the EU, in Switzerland and Norway may return their used electronic products free of charge to designated collectio...
Écrivez votre propre critique du dispositif
|
|