Évaluations - 3, GPA: 4.3 ( )

Fabricant : Audiovox Taille : 625.36 kb Nom Fichier : Langue d'enseignement:

3 INSTALLATION WRENCH (INCLUDED) ~ MOUNTING BOLT (SELECT LENGTH NEEDE FROM CHOICE OF LENGTHS INCLUDED) ' I G / STEEL CUP WASHERS RUBBER GROMMETS DRILL 5/16" DIA. HOLES TEMPLATE PER ~ I ~ APPLY A BEAD OF SEALANT AROUND BOTH SIDES OF HOLES ,,) ~ ~ ~..- - FLAT WASHERS JAM NUTS (TIGHTEN RRMLY) STEEL PLATE ~ ~~ USE THESE HOLES FOR CASE 580K ~ USE THESE HOLES / FOR ALL OTHER EQUIPMENT ~ ~ ~ J ~ ~c --:-:"" ---: ~ ~ ~~ BLACK WASHERS (6 PCS.) #6 BLACK SCREWS TRIMPLATE (6 PCS.) PLASTIC HOUSING 0 0~ RADIO SHAFT NUTS ~ Cab Wiring I. Route pre-installed antenna lead to mounting plate for connection to radio later in installation. 2. Locate the two wire (Red and Black) harness and the single Green/White stripe harness in this kit. 3. Connect the Black wire to vehicle ground using the crimp-on ring terminal and screw included. 4. Splice the Red wire to any + 12 volt accessory wire in the cab using the quick splice included. 5. Splice the Green /White stripe wire to any + 12 volt battery source in the cab using the quick splice connector included. 6. Route all three wires to the radio mounting plate for later connection. ( FIG. 5 CAB WIRNG CRIMP-ON RING TERMINAL RED TD + 12 VOLT ACC. QUICK SPLICE ~ CONNECTOR /" ~ BLACK ~ GREEN/WHITE WIRE "' TO VEHICLE ,," TO +'12 VOLT BATTER~ ~ GROUND (ONLY ON CE1 00/200/300) RADIO MOUNTING PLATE ~; Housing Wiring: I. Connect 2-pin Red/Black plug to mating 2-pin plug. 2. Connect Green/ White wire to mating Green/White wire. GREEN/WHITE RED FIG. 6 HOUSING WIRING 1,,--: BLACK /~I GREEN/WHITE ~ ONLY ON CE10012001300 RED ~ / BLACK REAR OF HOUSING ...

Téléchargez votre

Pour télécharger, entrez 2 chiffres :