Évaluations - , GPA: ( )

Instructions Attwood, Modèle 69341

Fabricant : Attwood
Taille : 441.12 kb
Nom Fichier : 69341-c-centric-seats.pdf

Langue d'enseignement:

Le document est chargé, s'il vous plaît patienter

Téléchargez votre Fermer

Le document est chargé, s'il vous plaît patienter

Téléchargez votre Fermer

Insert fasteners up through base and 3® Centric Seating System Installation Instructions Attwood marine hardware, navigational lighting, bilge pumps, and other marine accessories are specified more than any other brand by America’s best-known boat manufacturers as original equipment. Look to Attwood for quality replacement parts and marine accessories. SAVE THESE INSTRUCTIONS Form Number 69341 Rev. C 04-11 The Centric Seating System is designed for quality boat seating, with stationary- and swivel-mount attachment to fishing boat pedestals. The seats are constructed of tough materials that are resistant to moisture and corrosion. REQUIRED FOR INSTALLATION • Adjustable wrench. • 1/4" - 20 diameter stainless fasteners. Fastener types can be bolts, or thread cutting bolts. Length must be no longer than1"(25mm) longplusthe thickness of the attachment base. • Four flat and four lock washers. If installing optional 7029-1 Locking Latch: • Cordless drill and 5mm diameter drill bit. • Two (2) #68 x 3/16" tri-fold aluminum rivets with .040"-.5" grip range. WARNING Read installation instructions carefully before installing seats. Improper mounting may result in serious injury. MOUNTING SEAT TO BASE Centric Seats can be mounted to a fixed base, pedestal base, swivel base or slider mount. MOUNTING SEAT (Figure 1) NOTE: T-nuts are factory-installed. The T-nuts are 1/4" x 20-barrel style “Propel®” nuts. NOTE: Bolts must be 1/4"-20 thread, no longer than1"(25mm) long plusthe thickness of the mounting base. T-Nut (6) Base Thickness Lock Washer Flat Washer Fastener Figure 1 tighten into T-nuts of the seat. 2. Attach Back Panel using three (3) attachment clips fasteners supplied. INSTALL OPTIONAL LOCKING LATCH (Figure 2) The Locking Latch holds the seat closed tightly. Lift the latch to release the lock and raise the seat back. 1. Prior to installing back panel, hold the latch with Attwood® logo outward. Place top end into the latch pocket. 2. Use latch as template to drill two (2) 5mm (13/64") holes in the pocket. 3. Attach latch with two (2) #68 tri-fold rivets (not provided). 4. Test latch for proper holding. 5. Attach back panel by pressing it into the cover attachment clips. Figure 2 Attachment Clips (3) #68 Tri-Fold Rivets (Not Provided) Optional Latch Latch Pocket Back Panel Latch Engaged ATTWOOD LIMITED WARRANTY ATTWOOD CORPORATION, 1016 North Monroe, Lowell, Michigan 49331 (“Attwood”) warrants to the original consumer purchaser that Attwood brand products will be free from defects in materials and workmanship under normal use and service for one year from the date of original consumer purchases. This limited warranty is not applicable if the product has been damaged by accident, improper installation, unreasonable or improper use, lack of proper maintenance, unauthorized repairs or modifications, normal wear and tear, or other causes not arising out of defects in materials or workmanship. Attwood products are warranted for use on pleasure boats. Any other...