Évaluations - , GPA: ( )

Instructions Invacare, Modèle 6905A

Fabricant : Invacare
Taille : 171.2 kb
Nom Fichier : 1109697.pdf

Langue d'enseignement:

Le document est chargé, s'il vous plaît patienter

Téléchargez votre Fermer

Le document est chargé, s'il vous plaît patienter

Téléchargez votre Fermer

6905A, 6907A, 6908. SAVE THESE INSTRUCTION. NOTE: Check all parts for shipping damage, in case of damage, DO NOT use. Contact Carrier/Invacar. for further instructions. SAFETY SUMMAR. To ensure the safe and proper installation and use of footrest and scissor mechanism guards. these instructions MUST be followed. GENERAL WARNING DO NOT install this equipment without first reading and understanding thi. instruction sheet and the Invacare Mobile Recliners Manual, part numbe. 54000M107. If you are unable to understand the warnings, cautions an. instructions, contact a healthcare professional, dealer or technical personne. if applicable, before attempting to install this equipment - otherwise, injur. or damage may occur. INSTALLATION WARNING After ANY adjustments, repair, or service and BEFORE use, make sure that al. attaching hardware is tightened securely. Descriptio. Quantit. Footrest Cove. . Mechanism Cove. . Tie Wra. . INSTALLING FOOTREST GUARD AND SCISSO. MECHANISM GUAR. FOOTREST GUARD (FIGURE 1. NOTE: Right and left sides are determined from the user.s seated position. 1. Engage wheel locks. 2. Extend the footrest of the recliner. 3. Carefully tip the recliner onto the right side. Be sure there are no obstructions on o. around the floor before doing this. 4. Remove mounting bolt from support tube as shown in DETAIL .A. in FIGURE 1. 5. Install footrest guard around the footrest frame as shown in DETAIL .A. in FIGURE 1. NOTE: Footrest guard needs to be folded in two (2) locations so it will wrap entirely around the uppe. frame. Refer to the scored lines on the guard to determine where the folds should be. 6. Once folded, align the two (2) mounting holes of the footrest guard with the mountin. hole in the upper frame as shown in DETAIL .A. in FIGURE 1. 7. Using the mounting bolt, secure the footrest guard and upper frame to the support tub. as shown in DETAIL .A. in FIGURE 1. 8. With a tie wrap, secure the footrest guard to the upper side frame as shown in DETAI. .B. in FIGURE 1. NOTE: If necessary, trim excess tie wrap to prevent binding and pinching. CAUTION When installing tie-wrap, pull tie wrap tight but not too tight causing th. guard to buckle or deform. WARNING Tie wrap should be installed with the excess located on the interior side of th. footrest assembly. Failure to do so may result in serious injury. 9. Place chair in the upright position. Close the footrest. If binding or pinching of footres. guard occurs, call Invacare at the number listed on the back cover. 10. Carefully tip recliner onto the left side. Be sure there are no obstructions on or aroun. the floor before doing this. 11. Repeat STEPS 4-9 to install remaining footrest guard. DETAIL .A. DETAIL .B. - Side Vie. Mounting Bol. Scored Line. Tie Wra. Upper Fram. Footres. Guar. (Interior Side. Upper Fram. Support TubeTie WrapMountingHoles DO NOT use lowerframe for tie wrap. MountingBoltFootrest Guard FIGURE 1 - INSTALLING FOOTREST GUAR. INSTALLING SCISSOR MECHANISM GUARD (FIGURES...