6905A, 6907A, 6908. SAVE THESE INSTRUCTION. NOTE: Check all parts for shipping damage, in case of damage, DO NOT use. Contact Carrier/Invacar. for further instructions. SAFETY SUMMAR. To ensure the safe and proper installation and use of footrest and scissor mechanism guards. these instructions MUST be followed. GENERAL WARNING DO NOT install this equipment without first reading and understanding thi. instruction sheet and the Invacare Mobile Recliners Manual, part numbe. 54000M107. If you are u

Mounting Bol. Scored Line. Tie Wra. Upper Fram. Footres. Guar. (Interior Side. Upper Fram. Support TubeTie WrapMountingHoles DO NOT use lowerframe for tie wrap. MountingBoltFootrest Guard FIGURE 1 - INSTALLING FOOTREST GUAR. INSTALLING SCISSOR MECHANISM GUARD (FIGURES 2 AND 3. NOTE: Right and left sides are determined from the user's seated position. 1. Engage wheel locks. 2. Carefully tip recliner onto the right side. Be sure there are no obstructions on or aroun. the floor before doing this. N

1124320 Assembly, Installation and Operating Instructions Yes, you can: _SAVE THESE INSTRUCTIONS_ NOTE: Check ALL parts for shipping damage. In case of shipping damage, DO NOT use. Contact Carrier/Dealer for further instruction. SAFETY SUMMARY To ensure the safe installation, operation and use of the MPR Leg Extension Kit, these instructions MUST be followed: GENERAL WARNING DO NOT install or use this equipment without first reading and understanding these instructions. If you are unable

Remove four (4) existing bolts A, B, C and D from side frame as shown in FIGURE 3. 5. Position scissor mechanism guard against the side frame with the folded edge down. Refer to FIGURE 3. 6. Align holes of scissor mechanism guard with holes on side frame. 7. Secure scissor mechanism guard to side frame with existing bolts A, B, C, and D. 8. Perform one (1) of the following: A. FOR MODEL 6905A BUILT BEFORE 04/01/2002 - Install new side panel with kit no. 1109705 and using instruction sheet no. 11

Back Cane Adjustment Screw Arm Tube Cantilever Arm Armpad FIGURE 8.5 Adjusting the Angle of the Cantilever Arms Installing/Removing the Cantilever Arm Armpad NOTE: For this procedure, refer to FIGURE 8.6. NOTE: Reverse this procedure to remove the cantilever arm armpad. Secure the new armpad to the cantilever arm tube with two screws. Cantilever Arm Tube Cantilever Arm Armpad Screws FIGURE 8.6 Installing/Removing the Cantilever Arm Armpad Part No 1143238 47 Adjustable ASBA Seat SECTION 9—ADULT B

Otherwise injury or damage may occur. One of the following will occur when the drive lock.out feature has been activated: • TILT WARNING displays on the joystick or display unit. • SPM Inhibited displays on the joystick or display unit. •SPJ+ joysticks Only .Left to right chase alternating with a steady display. Drive lock.out is a feature designed to prevent the wheelchair from being driven after theseating system has been reclined beyond 20°* relative to the vertical position. The back can b