Évaluations - 3, GPA: 3.3
(
)
)
|
Facilité d'utilisation
Band Frequency Preset Number Lights while receiving an FM stereo signal. You can assign your favorite broadcasting station to the [D·M] button. As the result of doing that, your favorite broadcasting station can be received even if the unit is in the CD mode or other modes. (Default: FM 87.9 MHz) Note: For the use of an FM transmitter, it is useful for users to register applicable frequencies on D.M (Direct Memory). D.M station Calling Press [D.M] (DIRECT MEMORY). D.M station Setting Note: If the unit is turned off during receiving a broad- q Select a station you would like to preset. casting station via D·M, the unit starts again receiving w Hold down [D.M] (DIRECT MEMORY) for 2 sec. the broadcasting station via D·M by turning on the unit. or more. CQ-C7205U/C7105U Up to 6 stations can be preset in AM, FM1, FM2, and FM3 respectively. Manual station preset Radio Menu Display Station Preset(APM: AUTO PRESET MEMORY, P·SET: PRESET) Radio English Preset stations can be simply called up by pressing [}] (P-SET) or [{] (P-SET). Notes: 1 Tune in to a station. 2 Hold down [}] or [{] for 2 sec. or .Direct selection can be executed with [1] to [6] but-more. tons on remote control. .You can switch between 6 and 18 for FM presetting 3 Turn [VOL] to select a preset number. stations. (EACH BAND/ALL BAND) 4 Hold down [PUSH SEL] for 2 sec. or .Preset stations are changeable. (Preset Swap) more, and the frequency is stored at the selected preset number. Auto Preset Memory (APM) Stations with good receiving conditions automatically preset. 1 Select a band. 2 Hold down [BAND] for 2 sec. or more. The preset stations under best receiving conditions are received for 5 sec. each after presetting the sta- tions (SCAN). To stop scanning, press [}] or [{]. Note: New stations overwrite existing saved stations. Notes: number while selecting a preset station. (Preset Swap) .In step 2, a station can be registered by holding down the numeric button [1] to [6] for 2 sec. or more. .To stop presetting stations, press [DISP] (DISPLAY). .The operation above allows users to replace the current station with the station preset in the selected 1 Press [MENU] to display the menu dis-3 Press [MENU] to close the menu play. For using the remote control, hold down [SEL] (MENU) sec. or more. 2 Press For using the remote control, use (SET). screen. For using the remote control, hold down [SEL] for 2 sec. or more. Preset range for FM bands : Individual setting for FM1-3 each (default) : Setting of FM1-3 together CQ-C7205U/C7105U CD Player Cautions .This unit does not support 8 cm (3”) discs. .Refer to the section on “Notes on CD/CD Media (CD-ROM, .Do not use irregularly shaped discs. (a page 38) CD-R, CD-RW)” (a page 38). .Do not use discs that have a seal or label attached. .This unit does not support a MIX mode CD (a CD containing .To avoid damaging the face plate, do not push it down or both CD-DA and compressed audio data). In case of using place objects on it while it is open. such a CD, problems may occur such as anacoustic play. Do not pinch your finger or hand in the face plate when the back. face plate is in motion. .Do not insert foreign matter into the disc slots. When a disc is already loaded, press [SOURCE] to select the CD mode. 1 Press [uOPEN] to open the face plate. When a disc is already loaded ( lights), the disc will automatically be ejected. 2 Load a disc with the printed side facing up. 3 Select a desired portion. The face plate closes automatically, and the unit recognizes the disc and starts playing automatically, too. Track selection [7] (TRACK): Next track Printed side [6] (TRACK): Preceding track (press twice) Note: Hold down for fast forward/reverse. Pause Press [BAND] (h/ 5). Press again to cancel. 4 Press [uOPEN] to eject the disc. Note: The panel automatically closes after 20 seconds. Operation FlowCD Mode Display Track number Time CD-TEXT display Play Mode indicators Lights when the disc is Notes: Lights when each mode is loaded. .For scrolling text, hold down [DISP: DISPLAY] for 2 activated. sec. or more. .“NO TEXT” is displayed when there is no information on the disc. CQ-C7205U/C7105U to display the menu dis- Functions Only by Remote Control Unit Random, Repeat Play (CD Menu Display)(RANDOM, REPEAT) CD Player English to select a function to be [{]. 3 Press [PUSH SEL] to adjust. For using the remote control, use [BAND] (SET). 4 Press [MENU] to close the menu screen. For using the remote control, hold down [SEL] (MENU) for 2 sec. or more. : Random playback : Off (default) Playing the current track repeatedly : Enabled (default) : Disabled Play Mode Selection One-touch operation is available for selecting a track playing style by use of [RANDOM] or [REPEAT]. RANDOM Press [RANDOM]. Press again to cancel. REPEAT Press [REPEAT]. Press again to cancel. You can find your favorite track by playing first 10-sec. of each track. Press [SCAN]. Press again to cancel. A track can be directly selected. Example: track number 5 Press [#] (...