Évaluations - 5, GPA: 4
(
)
)
|
Facilité d'utilisation
Bundle all loose wires and fasten them with tape so they won’t fall down later. Now insert the stereo unit into the mounting collar. Congratulations! After making a few final checks, you’re ready to enjoy your new auto stereo system. □ Final Checks 1. Make sure that all wires are properly connected and insulated. 2. Make sure that the stereo unit is securely held in the mounting collar. 3. Turn on the ignition to check the unit for proper operation. If you have difficulties, consult your nearest authorized professional installer for assistance. CQ-DPG550/DPG500EUC 1 Installation Guide continued □ Installation Procedures 1. Secure the Mounting Collar ©. Insert Mounting Collar (D into the car’s dashboard, and bend mounting tabs out with a screwdriver. Screwdriver 2. Secure the rear of the unit a) Check the electrical connection by referring to this operating instructions. b) Connect the Mounting Bolt CD, using a suitable wrench. c) Insert the unit into Mounting Collar (D and push it in unit “click” is heard. Unit Lock Lever Make sure that the lock lever is flush with the mounting collar (not projecting outward). ■ Using the Rear Support Strap © Affix one end of the Rear Support Strap © to the rear of the unit, and the other end to the Fire Wall of Car, or some other metallic area. (D Plain Washer Fire Wall of Car 20 ■ Using the Rubber Cushion (Optional) (It there is an existing Rear Support Bracket on the Fire Wall of Car.) Cover Mounting Bolt (D on the rear of the unit with Rubber Cushion (Optional), and mount it into existing Rear Support Bracket. ~ Rear Support Bracket (existing on the car) \ Rubber Cushion (Optional) Mounting Bolt \ © Mounting Collar 3. Plug the Power Connector 4. After installation reconnect the negative (-) battery terminal. To Remove the Unit a) Remove the removable face plate as shown in next page. (To Remove the Removable Face Plate) b) Remove the trim plate with a screwdriver as shown in the figure. c) Pull out the unit while pushing the lock lever using screwdriver. d) Remove the unit pulling with both hands. CQ-DPG550/DPG500EUC 21 Installation Guide continued Press Anti-Theft System This unit is equipped with a removable face plate. By removing this face plate, the radio becomes totally inoperable. To Remove the Removable Face Plate (D Switch off the power. ©Press the release button (^). The removable face plate will be released. Contacts. (D Remove the removable face plate by pulling on the right side of the unit. Place the removable face plate in a supplied case. ® As shown in Fig.3, keep the removable face plate in the case. Then, you can bring the plate safely. © Removable face plate soft case To install the Removable Face Plate © Slide the left side of the removable face plate in place. (D Press the right end of the removable face plate until “click” is heard. Plastic Tab Cutout Removable Face Plate Fig. 4 22 CQ-OPG550/DPG500EUC Caution: 1. Before removing the removable face plate, make sure the power is off. 2. This removable face plate is not water-proof. Do not expose it to water or excessive moisture. 3. Do not remove the removable face plate, while driving your car. 4. Do not place the removable face plate on the dashboard or nearby areas where the temperature rises to high levels. 5. Do not touch the contacts on the removable face plate or on the main unit, since this may result in poor electrical contacts, 6. If dirt or other foreign substances get on the contacts, wipe them with a clean, dry cloth. Caution: • To prevent damage to the unit, be sure to follow the connection diagram below. • Remove the covering of the leads about 5 mm long from their end before connecting. • Do not insert the power connector into the unit until the wiring is completed. • Be sure to insulate any exposed wires from a possible short-circuit from the car chassis. Bundle all cables and keep cable terminals free from touching any metal parts. Only for CQ-DPG500EUC CQ-DPG550/DPG50QEUC ANTENNA Only for CQ-DPG550EUC Black (S*W-OUT) (MONO) While SUB-WOOFER OUT CONNECTOR (Rear) Black (Front)f Black Red(R) ^Red(R) Red White(L)Q g White(L) PREAMP OUT PREAMP OUT CONNECTOR CONNECTOR (Rear) (Front) White w/Black Stripe Gray w/Black Stripe SPEAKER LEAD FRONT SP j—SP ЭЖ0 LEFT SPEAKER RIGHT SPEAKER (FRONT) (FRONT) LEFT SPEAKER RIGHT SPEAKER (REAR) (REAR) PREAMP OUT CONNECTOR (Rear) BATTERY LEAD (Connect to car battery) POWER (+12V DC, negative ground only) GROUND (Connect to a clean, bare metallic part of your vehicle.) MOTOR ANTENNA RELAY CONTROL (Moves antenna up and down) CQ-DPG550/DPG500EUC 23 Troubleshooting □ Maintenance Your product is designed and manufactured to ensure a minimum of maintenance. Use a soft cloth for routine exterior cleaning. Never use benzine, thinner, or other solvent. □ When Something Doesn’t Work Check the charts on the next page for possible causes and solutions ...