Évaluations - 2, GPA: 3 ( )

Fabricant : Panasonic Taille : 2 mb Nom Fichier : CQDPX95EUC.PDF Langue d'enseignement:

“ADJUST’ is displayed. © Press and hold DISP again for more than 2 seconds. “12” blinks indicating the time setting mode is activated. © To set hours, press “VTUNE" or “TUNEA”. © Press DISP again for minute setting. ©To set minutes, press “VTUNE” or ‘TUNEA”. Hold “A” or “V” to change numbers rapidly. © When you have set the time, press DISP. Resetting the Time When you want to reset the time, press and hold DISP for more than 2 seconds to activate the time setting mode. Then, repeat step © to © above. Selecting the Clock Display Press DISP for clock display. Press DISP once again, the current audio display mode resumes. When power is turned oft while the time is displayed, the clock mode remains on. When the PWR is pressed again, the system is completly off. Note: Before you leave your car that has no ACC, be sure to switch power off. CQ-DPX95EUC Remote Control Basics Battery Replacement:- 1. Remove the battery holder. Pull the holder by the Position B while pushing Position A in the direction indicated by the arrow. 2. Replace the battery. Set a new battery properly with (+)side up as illustrated. 3. Insert the battery holder. Push in the holder to the original position. Note on Batteries:- Old batteries must immediately be removed and disposed. Battery Information: • Designated Battery: Panasonic Lithium Battery (CR2025) • Battery Life: 6 months with normal use (in normal room temperature) Back side Position A © Lithium battery © ÍVl Battery holder Position В Caution: Improper use of batteries may cause overheating, explosion or ignition, resulting in jury or fire. Battery leakage may cause damage to the unit. • Do not disassemble or short the batteries. Do not throw the batteries into the fire. • To avoid the risk of accident, keep the batteries out of reach of children. Names of Main Controls: О Power Button 0 Mode Button 0 3 • DSB Button О DISC UP/Down Button 0 SPANA/DIMMER Button 0 ATT Button О Volume Control Button © SEL Button 0 TUNE Button DISP Button BAND Button CQ-DPX95EUC Operating Procedures fh'emm,ahienruen7,e con,roller ,oward ,he sensor of General_ Power N O Power (Power Button) Press POWER to switch on the power. Press POWER again to switch off the power. V_y Mode Selection 0 MODE (Mode Button) Press MODE to switch the operation mode in the following order. Radio ^ CD Player (CD Changer Control) t_\ \_J Attenuator 0 ATT (ATT Button) • Press ATT. Volume will decrease to about 1/10 of its previous level. • Press ATT again to deactivate when listening at normal volume. \_- Volume O VVOLA (Volume Control Button) Press “A” or “V” to increase or decrease volume level. V_) 3*DS B 0 3»DSB Button Press to switch on or off 3#DSB and Loud as follows. 3 DSB OFF 3DSB0N 3DSB LOUD OFF LOUD OFF OFF t_i ^ (Refer to Page 7)_ Changing Audio Modes ^ 0 SEL Button Press SEL to switch the audio mode in the following order. Normal Mode * VOLUME * BASS * TREBLE * BALANCE t-SUB-W M FADER-- V_J Display Controls Dimmer Switching 0 Dimmer Button Press and hold DIMMER for more than 2 seconds to change the brightness of the LCD from one level to another in a cycle of 3 levels as follows: Dimmer 1 — Dimmer 2 -* Dimmer 3 (Bright) (Medium) (Dark) I_\ \_-> Spectrum Analyzer Display Switching 0 SPANA Button Press SPANA to change the spectrum analyzer display from one spectrum analyzer to another in a cycle of 6 kinds plus demonstration mode. SPANA 1 - SPANA2 - SPAN A3 - SPANA4 t 1 Demo Display «- SPANA6 ♦- SPANA5 Radio Selecting a Band 0 BAND (BAND select Button) Press BAND to select the band in sequence. FM1 * FM2 * FM3 AM t_ * v J Seek Tuning ^ 0 <,> (Seek Tuning Button) Press and hold “<” or “>" for more than a half second, then release. The radio will automatically stop on the next station. v J Manual Tuning ^ 0 <,> (Manual Tuning Button) Press “<” or “>” to turn the frequency downward or upward. V --J CQ-DPX95EUC 23 Remote Control Basics continued Compact Disc Player (When a disc is inserted, playback starts.) To Start CD Play © MODE (Mode Button) • Only when a disc is inserted, press to select CD play mode, and playback starts automatically. • When connecting with the CD changer, press repeatedly to select the mode as follows, Radio ^ CD Player ^ CD Changer Control *-AUX-* When a disc is inserted, CD play starts automatically regardless what mode you are being listened. Selecting a Track © <,> (Track Select Button) • Press “>” once to go to the next track. • Press “<” once to play from the beginning of the currently played track. • Press repeatedly tc stop forward or backward through all the tracks. V_J Searching a Track © <,> (Track Select Button) • Press and hold “<" or “>” for more than a half second to activate fast forward or reverse through the track. • Release to stop reverse or fast forward. v_J CD Changer Control (In connection with the CD Changer) Selecting a Track © <,> (Track Select Button) • Pr...

Téléchargez votre

Pour télécharger, entrez 2 chiffres :