. High-pitched tone isn't compensated for when in Tuner source. ? No sound can be heard, or the volume is low. . The fader or balance settings are set all the way to one side. . Center the fader and balance settings. . The input/output wires or wiring harness are connected incorrectly. . Reconnect the input/output wires or the wiring harness correctly. See the section on "Connecting Wires to Terminals". — 19 — English English Disc source ? "AVin" is displayed without . Unsupported disc changer . Use the disc changer mentioned INFORMATION of the section on (page 5). ? Can’t remove disc. . The cause is that more ACC switch was turned . The disc can only be removed switch being turned OFF. If more than 10 minutes has turn the ACC switch ON again ? The disc won’t insert. . There’s already another disc inserted. . Press the [ 0] button and remove the disc. ? Direct Track Search and Direct Album Search can’t be done. . Another function is ON. . Turn Random Play or other functions OFF. ? Track Search can't be done. . For the albums first or last song. . For each album, Track Search can't be done in the backward direction for the first song or in the forward direction for the last song. If the following situations, consult your nearest service center: • Even though the disc changer is connected, the Disc Changer source is not ON, with "AVin" showing in the display during the Changer Mode. • Even though no device (KCA-S210A, CA-C1AX, KDC-CPS89, KDC-CPS87, KDC-CX87, KDC-CPS85, KDC-CX85, KDC-CPS82 or KDC-CX82) is connected, the Auxiliary input is entered when switching modes. — 20 — Troubleshooting Troubleshooting E-0d: LOAd: IN (Blink): The protective temperature inside exceeds 60°C (140°F), . Cool down the unit by turning on the air conditioner. As the temperature falls below 60°C (140°F), the again. Discs are being exchanged in the Disc The CD player section is not operating . Reinsert the CD. If the CD cannot be ejected display continues to flash even when the CD been properly reinserted, please switch off the power and consult your nearest service center. . Clean the CD and load it correctly. E-10: Nothing has been recorded on the MD. E-11: No tracks are recorded on the MD, although it has a title. E-12: The faceplate of the slave unit being connected to this unit has been removed. . Replace it. E-77: The unit is malfunctioning for some reason. . Press the reset button on the unit. If the "E- 77" code does not disappear, consult your nearest service center. E-99: Something is wrong with the disc magazine. Or the unit is malfunctioning for some reason. . Check the disc magazine. And then press the reset button on the unit. If the "E-99" code does not disappear, consult your nearest service center. — 21 — English English Specifications FM tuner section Frequency range (200 ............87.9 MHz – 107.9 Frequency range (50 kHz ..............87.5 MHz – 108.0 Usable sensitivity (S/N = 30dB) .................... 9.3dBf (0.8 .V/75 .) Quieting Sensitivity (S/N = 50dB) ............... 15.2dBf (1.6 .V/75 .) Frequency response ( ± 3 dB) .................................30 Hz – 15 Signal to Noise ratio (MONO) ..............................................70 dB Selectivity ( ± 400 kHz) ....................................................... . 80 dB Stereo separation (1 kHz) ....................................................40 dB AM tuner section Frequency range (10 kHz space) ...................530 kHz – 1700 kHz Frequency range (9 kHz space) .....................531 kHz – 1611 kHz Usable sensitivity (S/N = 20dB) .............................28 dB. (25 .V) CD player section Laser diode ....................................................GaAlAs ( .=780 nm) Digital filter (D/A) ..........................
