Évaluations - 2, GPA: 3
(
)
)
|
Photos et spécifications Pioneer DEH-2600UI |
Facilité d'utilisation
! Do not install this unit where: — it may interfere with operation of the vehicle. — it may cause injury to a passenger as a result of a sudden stop. ! The semiconductor laser will be damaged if it overheats. Install this unit away from hot places such as near the heater outlet. of the unit match. DIN front/rear mount This unit can be properly installed using either front-mount or rear-mount installation. Use commercially available parts when installing. 2 Tighten two screws on each side. DIN Front-mount Removing and re-attaching the front 3 panel 1 Insert the mounting sleeve into the dash board. 1 You can remove the front panel to protect your For installation in shallow spaces, use the sup- unit from theft. plied mounting sleeve. If there is enough space, For details, refer to Removing the front panel and use the mounting sleeve that came with the ve- 2 Re-attaching the front panel on page 4. hicle. 1 Tapping screw ( 5 mm . 8 mm) 2 Mounting bracket 3 Dashboard or console 13 En Appendix Additional information Troubleshooting Symptoms are written in bold and causes in regular, non-indented text. Regular, indented text is used to indicate actions to be taken. The display automatically returns to the ordinary display. You did not perform any operation within about 30 seconds. Perform operation again. The repeat play range changes unexpectedly. Depending on the repeat play range, the selected range may change when another folder or track is being selected or during fast forwarding/reversing. Select the repeat play range again. A subfolder is not played back. Subfolders cannot be played when FLD (folder repeat) is selected. Select another repeat play range. NO XXXX appears when a display is changed (NO TITLE, for example) . There is no embedded text information. Switch the display or play another track/file. The unit is malfunctioning. There is interference. You are using a device, such as a cellular phone, that may cause audible interference. Move electrical devices that may be causing the interference away from the unit. Error messages When you contact your dealer or your nearest Pioneer Service Center, be sure to note the error message. 14 En Additional information Symptoms are written in bold and causes in regular, non-indented text. Regular, indented text is used to indicate actions to be taken. Common AMP ERROR This unit fails to operate or the speaker connection is incorrect; the protective circuit is activated. Check the speaker connection. If the message fails to disappear even after the engine is switched off/on, contact your dealer or an authorized Pioneer Service Station for assistance. CD player ERROR-07, 11, 12, 17, 30 The disc is dirty. Clean the disc. The disc is scratched. Replace the disc. ERROR-07, 10, 11, 12, 15, 17, 30, A0 There is an electrical or mechanical error. Turn the ignition switch OFF and back ON, or switch to a different source, then back to the CD player. ERROR-15 The inserted disc is blank. Replace the disc. ERROR-23 Unsupported CD format. Replace the disc. FORMAT READ Sometimes there is a delay between the start of play back and when you start to hear any sound. Wait until the message disappears and you hear sound. NO AUDIO The inserted disc does not contain any playable files. Replace the disc. SKIPPED The inserted disc contains DRM protected files. The protected files are skipped. PROTECT All the files on the inserted disc are embedded with DRM. Replace the disc. USB storage device/iPod FORMAT READ Sometimes there is a delay between the start of play back and when you start to hear any sound. Wait until the message disappears and you hear sound. NO AUDIO There are no songs. Transfer the audio files to the USB storage device and connect. The connected USB storage device has security en abled. Follow the USB storage device instructions to disable the security. SKIPPED The connected USB storage device contains DRM protected files. The protected files are skipped. PROTECT All the files on the connected USB storage device are embedded with DRM. Replace the USB storage device. N/ A USB The connected USB device is not supported by this unit. ! Connect a USB Mass Storage Class compliant device. ! Disconnect your device and replace it with a compatible USB storage device. CHECK USB The USB connector or USB cable has short circuited. Check that the USB connector or USB cable is not caught in something or damaged. CHECK USB The connected USB storage device consumes more than maximum allowable current. Disconnect the USB storage device and do not use it. Turn the ignition switch to OFF, then to ACC or ON and then connect only compliant USB storage devices. CHECK USB The iPod operates correctly but does not charge. Make sure the connection cable for the iPod has not shorted out (e.g. , not caught in metal objects) . After checking, turn the ignition switch OFF and back ON, or disconnect the iPod and reconnect. ERROR-19 Communication failed. Perform one of the following operations. –Turn...
Ce manuel est également adapté pour les modèles :Unité - DEH-X3600UI (4.77 mb)