Évaluations - 8, GPA: 4.6
(
)
)
|
Photos et spécifications Pioneer DEH-5000UB |
Par ce dispositif a également d'autres instructions :
Unité - DEH-5000UB (1.07 mb)
Unité - DEH-5000UB (1005.61 kb)
Unité - DEH-5000UB (687.41 kb)
Facilité d'utilisation
Do not connect anything with Green and Green/black leads. (Connecting the units ~) (^ English ^^Note • When this unit is installed in a vehicle without ACC (accessory) position on the ignition switch, red cable must be wired to the terminal that can detect the operation of the ignition key. Otherwise battery drain may result. ACC position No ACC position • Use this unit in other than the following conditions could result in fire or malfunction. — Vehicles with a 12-volt battery and negative grounding. —Speakers with 50 W (output value) and 4 ohm to 8 ohm (impedance value). • To prevent short-circuit, overheating or malfunction, be sure to follow the directions below. — Disconnect the negative terminal of the battery before installation. —Secure the wiring with cable clamps or adhesive tape. To protect the wiring, wrap adhesive tape around them where they lie against metal parts. — Place all cables away from moving parts, such as gear shift and seat rails. — Place all cables away from hot places, such as near the heater outlet. — Do not pass the yellow cable through a hole Into the engine compartment to connect to a battery. — Cover any disconnected cable connectors with nsuiating tape. — Do not shorten any cables. — Never cut the insulation of the power cable of this unit in order to share the power to other equipment. Current capacity of the cable is limited. — Use afuse of the rating prescribed. — Never wire the speaker negative cable directly to ground. — Never band together multiple speaker’s negative cables. • Control signal is output through blue/white cable when this unit is powered on. Connect it to an external power amp’s system remote control or the vehicle’s auto-antenna relay control terminal (max. 300 mA, 12 V DC). If the vehicle is eguipped with a glass antenna, connect it to the antenna booster power supply terminal. • Never connect blue/white cable to external power amp’s power terminal. Also, never connect it to the power terminal of the auto antenna. Otherwise, battery drain or malfunction may result. • Black cable is ground. This cable and other product’s ground cable (especially, high-current products such as power amp) must be wired separately. Otherwise, fire or malfunction may result if they are accidentally detached. (Connecting the units ~) (( English Connection Diagram 1. USB Input (DEH-5000UB) Connect to separately sold USB device. 2. Rear output or subwoofer output 3. Antenna jack 4. Fuse (10 A) 5. USB input (DEH-50UB) 6. Wired remote input Hard-wired remote control adaptor can be connected (sold separately). 7. AUX jack (3.5 0) Use a stereo mini plug cable to connect with auxiliary device. 8. This product 9. USB cable (DEH-50UB) Connect to separately sold USB device. 10.Note Depending on the kind of vehicle, the function of 3* and 5* may be different. In this case, be sure to connect 2* to 5* and 4* to 3*. 11 .Connect leads of the same color to each other. 12.Cap (1*) Do no...
Ce manuel est également adapté pour les modèles :Unité - DEH-4000UB (1.13 mb)
Unité - DEH-50UB (1.13 mb)