Log:
Évaluations - 5, GPA: 3.8 ( )

Instructions Vitek, Modèle VT-3633

Fabricant : Vitek
Taille : 919.04 kb
Nom Fichier : Vitek-VT-3633-Pdf-Rus.Pdf
Langue d'enseignement: ruen
Aller à la télécharger



Facilité d'utilisation


I 2 | |1 | (-) (+) FRONT RIGHT SP. I 4 I I 4 | |3 | AUTOANT (+) (-) (+) FRONT LEFTSP. I 5 I I 6 | I 5 | GND B+ (-) (+) REAR LEFTSP. I 8 I |7 I I 8 | I 7 | (-) (+) СТОРОНАA 4: Желтый 5: Голубой 7: Красный 8: Черный SIDE А Yellow Blue Red Black СТОРОНА В 1: Фиолетовый 2: Фисгеговый/Чершй 3: Серый 4: Серый/Черный 5: Белый 6: Белый/Черный 7: Зеленый 8: Зеленый/Черный SIDE В Violet Violet/Black Gray Gray/Black White White/Black Green Green/Black LINE OUT - GREY: RED (R) WHITE (L) ПОДСОЕДИНЕНИЕ 2 ДИНАМИКОВ СТАНДАРТНЫЙ СОЕДИНИТЕЛЬНЫЙ ПРОВОД (ISO) 2 SPEAKER WIRING ISO CONNECTOR BACK UP(+) AUTOANT (+) GND B+ B FRONT RIGHT SP. (-) (+) FRONT LEFTSP. (-) (+) СТОРОНАA 4: Желтый 5: Голубой 7: Красный 8: Черный SIDEA Yellow Blue Red Black СТОРОНА В 3: Серый 4: Серый/ Черный 5: Белый 6: Белый/ Черный SIDE В 3: Gray 4: Gray/Black 5: White 6: White/Black 14 ENGLISH INSTALLATION PRECAUTIONS • Choose the mounting location carefully so that the unit will not interfere with the normal driving functions of the driver. • Avoid installing the unit where it would be subject to high temperatures, such as from direct sunlight or hot air from the heater, or where it would be subject to dust, dirt or excessive vibration. • Use only the supplied mounting hardware for a safe and secure installation. • Be sure to remove the front panel before installing the unit. NOTE: Inclination angle for car radio installation must not exceed 30° otherwise the front panel will not open. Note: Keep the release key in the safe place, as you may need it in future to remove the unit from the car. TO SUPPORT THE UNIT 1. UNIT 2. RELEASE CASE 3. HEX NUT 4. LOCKWASHER 5. PLAIN WASHER 6. CAR BODY 7. REAR SUPPORT STRAP 8. TAPPING SCREW 9. M5X 15 HEX BOLT 3633.qxd 16.02.04 16:14 Page 6 ~Q- ENGLISH Detaching and attaching the front panel The front panel of this unit can be detached in order to prevent the unit from being stolen. DETACHING THE FRONT PANEL Before detaching the front panel, be sure to press the POWER OFF button first. Then press the button (19) and detach the panel by pulling it towards you as illustrated. Note: Be sure not to drop the panel when detaching it from the unit. • Make sure that the front panel is the right way up when attaching it to the unit as it cannot be attached upside down. • Do not press the front panel hard against the unit when attaching it. It can be easily attached by pressing it lightly against the unit. • When you carry the front panel with you, put it in the supplied front panel case. • Do not press hard or give excessive pressure to the display window of the front panel when attaching it to the unit. 1. POWER ON/OFF (PWR1 By pressing this key, the unit is on and off. This unit is turned on by pressing any key. 2. SELECT BUTTON: BASS/TREBLE/BALANCE/FADER (SEL) Press to select the desired mode: VOLUME - BASS - TREBLE - BALANCE - FADER - VOLUME AUDIO DSP CONTROLS (2) When press the SEL button for more than 2 seconds, it is activated as selecting mode of these function. I SEL |-1 DSP I-1 +/-VOL |-1 POP M — ROCK M — CLASS — FLAT M — DSPOFF] DSP can be selected by VOL UP and DOWN key. POP M-ROCK M-CLASS-FLAT M-DSP OFF BEEP MODE (2) When press the SEL button for more than 2 seconds, it is activated as selecting mode of these function. I SEL |-1 DSP |-1 SEL I-1 BEEP I-1 +/-VOL |-|ON/OFF| BEEP ON: BEEP sound can be heard from speaker when the buttons are pressed. SEEK MODE (2) When press the SEL button for more than 2 seconds, it is activated as selecting mode of these function. I SEL |-1 DSP I-1 SEL |-1 BEEP |-1 SEL |-|SEEK|-1 +/-VOL |-1 SEEK1/SEEK2] SEEK 1: When SEEK 1 mode is activated, AUTO SEEK SCAN is stopped when station is detected even user still push SEEK button. SEEK 2: Auto SEEK SCAN is not stopped even station is detected if user push SEEK button. When release this SEEK button, then stop when station is defected. VOL LAST/ADJUST (2) When press the SEL button for more than 2 seconds, it is activated as selecting mode of these function. 4 РУССКИЙ 18. КНОПКИ УСКОРЕННОЙ ПЕРЕМОТКИ ВПЕРЕД »/ НАЗАД « И РЕВЕРСА При нажатии на одну из этих кнопок включ...


Écrivez votre propre critique du dispositif



Texte du message
Votre nom :
Entrez les deux chiffres :
capcha





catégories