Évaluations - 0, GPA: 0
(
)
)
|
Facilité d'utilisation
a um conector de alimentacao auxiliar do automovel к вспомогательному автомобильному разъему питания Notes of connection example Notes on the control leads •The power aerial control lead (blue) supplies +12 V DC when you turn on the tuner or when you activate the AF (Alternative Frequency), TA (Traffic Announcement) function. •A power aerial without a relay box cannot be used with this unit. •When your car has built-in FM/MW/ LW aerial in the rear/side glass, it is necessary to connect the power aerial control lead (blue) or the accessory power input lead (red) to the power terminal of the existing aerial booster. For details, consult your dealer. Warning If you have a power aerial without a relay box, connecting this unit with the supplied power connecting cord 8 may damage the aerial. Memory hold connection When the yellow power input lead is connected, power will always be supplied to the memory circuit even when the ignition switch is turned off. Notes on speaker connection •Before connecting the speakers, turn the unit off. •Use speakers with an impedance of 4 to 8 ohms, and with adequate power handling capacities. Otherwise, the speakers may be damaged. •Do not connect the terminals of the speaker system to the car chassis, and do not connect the terminals of the right speaker with those of the left speaker. •Do not attempt to connect the speakers in parallel. •Do not connect any active speakers (with built-in amplifiers) to the speaker terminals of the unit. Doing so may damage the active speakers. Therefore, be sure to connect passive speakers to these terminals. Warning when installing in a car without ACC (accessory) position on the ignition key switch Be sure to press (OFF) on the unit for two seconds to turn off the clock display after turning off the engine. When you press (OFF) only momentarily, the clock display does not turn off and this causes battery wear. Notas de ejemplo de conexiones Notas sobre conductores de control • El conductor (azul) de control de la antena motorizada suministra +12 V CC al encender el sintonizador o al activar la funcion AF (Frecuencias alternativas) o TA (Anuncios de trafico). •Con esta unidad no podra utilizarse una antena motorizada sin caja de reles. •Si el automovil dispone de una antena de FM/MW/LW incorporada en el cristal trasero/lateral, sera necesario conectar el cable de control de antena motorizada (azul) o el cable de entrada de alimentacion auxiliar (rojo) al terminal de alimentacion del amplificador de antena existente. Para obtener informacion detallada, consulte a su proveedor. Advertencia Si dispone de una antena motorizada sin dispositivo de rele, la conexion de esta unidad con el cable de conexion de alimentacion 8 suministrado puede danar la antena. Conexion para proteccion de la memoria Si conecta el conductor de entrada amarillo, el circuito de la me...
Ce manuel est également adapté pour les modèles :Unité - CDX-C5000R (254.22 kb)
Unité - CDX-C5000RV (254.22 kb)
Unité - CDX-C5000RX (254.22 kb)