Évaluations - 0, GPA: 0
(
)
)
|
Par ce dispositif a également d'autres instructions :
Facilité d'utilisation
•Do not get the wires under a screw, or caught in moving parts (e.g., seat railing). •Before making connections, turn the car ignition off to avoid short circuits. •Connect the yellow and red power input leads only after all other leads have been connected. •Run all earth wires to a common earth point. •Be sure to insulate any loose unconnected wires with electrical tape for safety. Notes on the power supply cord (yellow) •When connecting this unit in combination with other stereo components, the connected car circuit’s rating must be higher than the sum of each component’s fuse. •When no car circuits are rated high enough, connect the unit directly to the battery. Parts Iist (1) •The numbers in the list are keyed to those in the instructions. •The bracket 1 is attached to the unit before shipping. Before mounting the unit, use the release keys 7 to remove the bracket 1 from the unit. For details, see “Removing the bracket (4)” on the reverse side of the sheet. • Keep the release keys 7 for future use as they are also necessary if you remove the unit from your car. Caution Handle the bracket 1 carefully to avoid injuring your fingers. Note Before installing, make sure that the catches on both sides of the bracket 1 are bent inwards 2 mm. If the catches are straight or bent outwards, the unit will not be installed securely and may spring out. Installation/Connections .............. FM/MW/LW Compact Disc Player Connection example (2) Notes (2-A) • Be sure to connect the black earth lead cord before connecting the amplifier. • If you connect an optional power amplifier and do not use the built-in amplifier, the beep sound will be deactivated. Tip (2-B- ) For connecting two or more CD/MD changers, the source selector XA-C30 (optional) is necessary. Connection diagram (3) 1 To a metal surface of the car First connect the black earth lead, then connect the orange/white striped, yellow, and red power input leads. 2 To the power aerial control lead or power supply lead of aerial booster amplifier Notes • It is not necessary to connect this lead if there is no power aerial or aerial booster, or with a manually-operated telescopic aerial. • When your car has a built-in FM/MW/LW aerial in the rear/side glass, see “Notes on the control and power supply leads.” 3 To AMP REMOTE IN of an optional power amplifier This connection is only for amplifiers. Connecting any other system may damage the unit. 4 To the interface cable of a car telephone 5 To a car’s illumination signal Be sure to connect the black earth lead to a metal surface of the car first. 6 To the +12 V power terminal which is energised in the accessory position of the ignition key switch Notes • If there is no accessory position, connect to the +12 V power (battery) terminal which is energised at all times. Be sure to connect the black earth lead to a metal surface of the c...