Note: the control panel must be attached into the T-Joint. 2. Press the right side of the panel until a "click" sound is heard. Detaching the front panel 1. Press the REL button on the front panel. 2. Push the panel to the right and pull off the panel. Caution: The control panel can easily be damaged by shocks. After removing it, place it in a protective case and be careful not to drop it or subject it to strong shocks. The rear connector that connects the main unit and the control panel

2). Attaching the control panel 1. Insert the left side of the control panel into the main unit (pic. 3) Note: the control panel must be attached into the T-Joint. 2. Press the right side of the control panel until a "click" sound is heard. 3. Close the panel. Caution: Pic. 3 DO NOT insert the control panel from the right side. It can damage the control panel. The control panel can easily be damaged by shocks. After removing it, place it in a protective case and be careful not to drop it

When traffic announcement is received the unit will temporarily switch to the tuner mode (regardless of the current mode) and begin broadcasting the announcement. After the traffic announcement is over, it will return to the previous mode and volume level. To interrupt traffic announcement press TA button shortly; it will not switch off the TA mode. PTY (Program Type) This radio will allow you to select the type of program required, and will search for a station broadcasting that type of progr

When user releases the button, then seek stops when station is detected. VOL LAST - VOL ADJUST When VOL LAST is selected, the volume level adjusted by the user is selected whenever the power is on and off. When VOL ADJ is selected you can adjust the volume level that will be active whenever the power is on. 16 Disc operations Loading/Eject a disc • Open the front panel. Insert the disc with the printed side facing upward into the slot. Close the panel. The CD will play automatically. • Ope

And use a cotton swab soaked in isopropyl alcohol to clean the socket on the back of the control panel. 6 Connection scheme Notes: - In spite of having any kinds of speaker system, must use 4 ohms impedance of speaker to reduce the distortion during high volume level. - Prohibit to make the conductors of auto antenna and ground touch with each other. 7 Panel controls Front panel 1. OPEN BUTTON Press it to flip down the front panel to insert or eject the disc. 2. i / ► / ^ EQ3/ ▼ MUTE

For safety, it is strongly recommended to read this manual carefully before connecting, operating and/or adjusting the product and keep the manual for reference in the future. Table of contents Table of contents....................................................................................................................................................................................2 Important safeguards....................................................................................

Wipe in a straight motion from the center to the edge. Never use thinner benzine, record cleaner or anti static spray on a compact disc. Such chemicals can damage its plastic surface. 27 Troubleshooting guide Symptom Cause Solution No power The car ignition is not on. The fuse is blown. If the power supply is properly connected to the car accessory switch the ignition key to "ACC". Replace the fuse. Disc cannot be loaded. There is a disc inside the unit. Remove the disc from the unit. Disc

Rotate the VOL knob to select the desired mode: TA ALARM and TA SEEK. - TA SEEK When newly tuned station does not receive TP information for 5 seconds, the radio retunes to next station which has not the same station (PI - Program Information) as the last station, but has the TP information. When TP information gets lost at the current station for retune time which is set by RETUNE SHORT (30 seconds) or RETUNE LONG (90 seconds), the radio starts to retune to next same PI station. When same PI

BEEP OFF: no beep sound is heard. SEEK (for Tuner mode) 14 Select SEEK 1 or SEEK 2. Seek 1: In Radio mode rotate and hold PREV/NEXT knob. The radio will seek the next strong and clear frequency station. Repeat to seek more stations in your listening area with a strong signal. Seek 2: In Radio mode rotate and hold PREV/NEXT buttons for station search. The search will not cease until you release the knob. VOL LAST/ADJUST In this mode the unit will be turned on with the same volume level at

For safety, it is strongly recommended to read this manual carefully before connecting, operating and/or adjusting the product and keep the manual for reference in the future. Table of contents Table of contents..........................................................................................................2 Important safeguards....................................................................................................3 Installation/ Connections..............................