Évaluations - 3, GPA: 4 ( )

Fabricant : Audiovox Taille : 1.06 mb Nom Fichier : Langue d'enseignement:

Failure to do so may cause damage to console or installed components. Figure 16 2. Raise overhead console into approximate position and connect wiring to O.E. components. 3. Loosely fit console against headliner. Check that console is centered in vehicle and matches all contours of headliner. While supporting console in mounting position, loosely install using two (2) 6-32 X 3/4" screws (item 10 pg 2) through the smaller holes in bracket on console into threaded clips on mounting bracket. See Figure 17. Figure 18 1. Construct a jumper harness that will connect the vehicle’s dome light wires to the lights in the console and video system. Connect the white wires from lights to the O.E. white wire. Connect the black wires from lights to the O.E. orange wires. Do not use O.E. black wire. See Figure 16. Figure 17 4. Secure front of console using two (2 ) # 8 X 1 1/4" PWH screws (item 3 pg 2) in front of console. See Figure 17. Caution: Do not overtighten screws or damage to vehicle roof may occur. 5. Open sunglass holder on O.E. console. Install two ( 2 ) # 8 x 1 1/4" PWH screws (item 3 pg 2) in dimple area. See Figure. 17. Caution: Do not overtighten screws or damage to vehicle roof may occur. 6. Tighten 6-32 X 3/4" screws previously installed in step 3. 11 7. Release video screen from locked position. Lower video screen to viewing position for access to mounting locations in top of video system housing. 8. Raise video system into approximate position and connect all wiring to components. Route video cable through hole in mounting bracket. Connect wiring and cabling to video system per instructions included with video system. 9. Check function of all components and lights. See operating instructions for video system operations check. For further assistance, refer to the video system manual for the technical support phone number listed for your area. 10. Insert video system into opening in console. Note: Make sure that wires do not get pinched between bosses on video system and console. Align holes in housing with threaded clips in mounting bracket. Loosely install four (4) 6-32 X 3/4" screws (item 10 pg 2) and four (4) 3.5 mm washers (item 11 pg 2). Caution: Do not overtighten screws. See Figure 19. 11. Raise video screen into locked position. 12. Attach wiring to rear light (item 6 pg 2) per step 1. Install light in console and secure to plywood above Figure 19 headliner using three (3) # 8 x 2 1/2" PFH screws (item 2 pg 2). See Fig. 20. Tighten screws until rear edge of console contacts headliner. Caution: Do not overtighten screws or damage to vehicle roof may occur. 13. Install trim ring (item 7 pg 2) around light. 14. Attach O.E. wiring to rear A/C control head. Carefully snap O.E. trim ring around control head. Insert control head into opening and press firmly to engage tabs. 15. Check function of all components and lights. If O.E. console was equipped with a Homelinka Figure 20 transmitter, refer to the vehicle owner’s manual for reprogramming instructions. 12 ...

Téléchargez votre

Pour télécharger, entrez 2 chiffres :