Évaluations - 4, GPA: 4.8
(
)
)
|
Facilité d'utilisation
PREPARATION OF VEHICLE INTERIOR FIGURE 1 3. Install console mounting bracket (item 2 pg 2) over O.E. bracket on roof brace. Secure rear of bracket using (2) two O.E. screws. Secure front of bracket using (2) two #8 x 3/4" screws (item 1 pg 2) See Figure 2. INSTALLATION INSTRUCTION # 44-0026B 3 1. Carefully trim headliner as shown. Caution: Before cutting headliner material, check for wiring or other componentry above headliner. Cut only where indicated. Make sure that the 8 1/2" cut is centered left to right in vehicle. See Figure 1. 2. Remove and retain (2) two O.E. screws which secures O.E. bracket to roof brace. See Fig. 1. FIGURE 2 II. PREPARATION OF CONSOLE FOR INSTALLATION 4. Install the video system in console (item 3 pg 2) and secure using hardware supplied with video system. Start all screws before tightening. Begin with the rear center screw, then alternately tighten screws around the perimeter of pod. See Figure 3. Refer to owner’s manual supplied with video system. Caution: Do not overtighten screws. July 7, 1999 Printed in the U.S.A. III. INSTALLATION OF CONSOLE 5. Install and route all video and audio cables, and any other added component requirements to their respective places in the vehicle. Refer to component installation instructions for wiring diagrams. The suggested routing of the video system cable is as follows: Above the headliner from video system to B-pillar. Rearward to the C- pillar. Down the C-pillar to the floor. Route the power lead to an accessory controlled source. Connect the ground lead to the vehicle chassis. Route the remaining wiring (RCA plugs, Remote Sensor extension, etc.) to the VCP location. See Figure 4. Connect per instructions included with the video system. If video system if to be used as a television, install an appropriate antenna per instructions included with the antenna. 6. Construct a jumper harness that will connect the vehicle’s dome light wires to the lights in video system. Connect the white wire from video system to the O.E. black/ blue wire. Connect black wire from video system to the chassis ground. 7. Place the overhead console in vehicle and loosely fit it against headliner. Check that console is centered in vehicle and matches all contours of headliner. Using an awl or similar tool, align the rear mounting hole with hole in bracket. Apply upward pressure to console and secure using (1) one #8 x 3/4" screw. See Fig. 5. Release video screen from locked position and mark the locations of the mounting bosses in the video system on the mounting bracket using an awl or similar tool. Remove console from vehicle. 8. Using a 3/32” drill bit, drill (4) four holes in mounting bracket at locations previously marked. FIGURE 5 9. Raise console into approximate position and connect all wiring to components. Route video cable through hole in bracket and connect wiring and cabling to video system per instructions included with video system. 10. Check function of all components and lights. See operatin...
Ce manuel est également adapté pour les modèles :Vidéo de voiture - 50-0245x-014 SERIES (294.81 kb)