On cleaning Clean the speaker cabinets with a soft cloth lightly moistened with a mild detergent solution or water. Do not use any type of abrasive pad, scouring powder or solvent such as alcohol or benzine. The volume level should not be turned up to the point of distortion. If the volume level is too high, the speaker protection circuit activates, and the sound level drops suddenly. This is not a malfunction. In this case, lower the volume level and wait for a few moments until the unit resume

. The alarm will only sound if the built-in amplifier is used. Notes (.-B) . You cannot use multiple auxiliary devices simultaneously, even if they are connected to different terminals. . To connect an iPod via RC-202IPV, make sure to connect the video output plug to AUX1 IN. Connection diagram . To a common ground (earth) point First connect the black ground (earth) lead, then connect the yellow and red power supply leads. . To the power antenna (aerial) control lead or the power supply lead of

. If no car circuits are rated high enough, connect the unit directly to the battery. Parts list . The numbers in the list correspond to those in the instructions. . The bracket . is attached to the unit before shipping. Before mounting the unit, use the release keys . to remove the bracket . from the unit. For details, see “Removing the bracket (.)” on the reverse side of the sheet. . Keep the release keys . for future use as they are also necessary if you remove the unit from your car. . The s

*4 RCA pin cord (not supplied) *5 For details on connecting to the parking brake switch cord, see “Connecting the parking brake lead (.)” on the reverse side. *6 not supplied *7 The sound is output from this terminal only when ZONE x ZONE is activated. This terminal outputs a fixed level regardless of the volume control of the unit. *8 A separate adaptor may be required. *9 USB connection cable RC-202IPV (not supplied). To connect an iPod via RC-202IPV, make sure to connect the video output plug

are bent inwards 3.5 mm (5/32 in). If the catches are straight or bent outwards, the unit will not be installed securely and may spring out. Connection example Notes (.-A) . Be sure to connect the ground (earth) lead before connecting the amplifier. . The alarm will only sound if the built-in amplifier is used. Note (.-B) You cannot use multiple auxiliary devices simultaneously, even if they are connected to different terminals. Connection diagram . To AMP REMOTE IN of an optional power amplifie

•Do not get the wires under a screw, or caught in moving parts (e.g. seat railing). •Before making connections, turn the car ignition off to avoid short circuits. •Connect the red power input leads only after all other leads have been connected. •Run all ground wires to a common ground point. Fuse replacement When replacing the fuse, be sure to use one matching the amperage rating stated on the original fuse. If the fuse blows, check the power connection and replace the fuse. If the fuse blows a