To avoid being scalded, make sure all connections are tight and that the water fl ow is directed away from any person, see Figures 2 and 5. FIGURE 5. 5. Disconnect the vent pipe from the blower assembly where it connects to the water heater. In most installations the vent pipe can be lifted off after any screw or other attached devices are removed. Make sure existing vent complies with maximum and minimum vent lengths on page 17. 6. If you have copper piping to the water heater, the two copper w

No hacer caso de esta advertencia podria resultar en la MUERTE O GRAVES LESIONES CORPORALES. Owner’s Manual THE ECONOMIZER™ 6 GAS WATER HEATER POWER VENTED GAS MODELS WITH HOT SURFACE IGNITION FOR POTABLE WATER HEATING ONLY. NOT SUITABLE FOR SPACE HEATING. NOT FOR USE IN MOBILE HOMES. MODEL NO. 153.332040 40 Gallon Nat 153.332050 50 Gallon Nat 153.332060 40 Gallon LP 153.332070 50 Gallon LP C3 Technology® Gas Water Heaters meet the new ANSI Z21.10.1 standard that deals with the accidental or uni

7. Do not plug in power cord until vent system is completely installed. This power vent heater operates on 110-120 Vac, therefore a grounded outlet must be within reach of the six (6) foot (1.8 m) flexible power cord supplied with the unit (see Figure 1). The power cord supplied may be used only where local codes permit. If local codes do not permit the use of a flexible power supply cord: a.) Make sure the unit is unplugged from wall outlet. Remove screws and open panel on front of control box.

Because of the suddenness and amount of water, condensate water may be diagnosed as a “tank leak”. After the water in the tank warms up (about 1-2 hours), the condition should disappear. Do not assume the water heater is leaking until there has been enough time for the water in the tank to warm up. An undersized water heater will cause more condensation. The water heater must be sized properly to meet the family’s demands for hot water including dishwashers, washing machines and shower heads. Ex