Évaluations - 0, GPA: 0
(
)
)
|
Facilité d'utilisation
CANCELING THE ALARM COMPLETELY To cancel the set alarm time before it goes off, or during the alarm call: • Adjust AL 1 or AL 2 to OFF position. REPEAT ALARM This repeats your alarm call at 6-7-minute intervals. 1 During the alarm call, press REPEAT ALARM/SLEEP OFF. SLEEP About Sleep This set has a built-in timer which enables the set to be automatically switched off during radio playback after a set period of time. This allows you to lie back, listen and fall asleep. The maximum sleep time is 59 minutes. Setting SLEEP 1 Check that the clock control is in CLOCK position. 2 Set OFF • RADIO • AUX to OFF position. 3 To set the sleep function, do one of the following: • Press and hold SLEEP. ™ The display will begin to count down from 0:59 to 0:00 minutes. • Hold down SLEEP, and press UP/DOWN repeatedly to adjust sleep time from 59 minutes downward. ™ To cancel sleep, press REPEAT ALARM/SLEEP OFF. CONNECTING AN EXTERNAL DEVICE You can listen to your favourite music of the connected external device through your AJ3226’s speakers. 1 Adjust OFF • RADIO • AUX to select AUX. 2 Connect the AUX-IN cable of the set to an AUDIO OUT or headphone jack on an external device (such as MP3 player, or CD player). Notes for battery disposal Your product contains batteries covered by the European Directive 2006/66/EC, which cannot be disposed with normal household waste. Please inform yourself about the local rules on separate collection of batteries because correct disposal helps to prevent negative consequences for the environmental and human health. Specifications AC Power.............................................220 – 230 V / 50 Hz Power Consumption Active...........................................................................5 W Standby.....................................................................<2 W Dimensions (w x d x h)....................174 x 62 x 159 (mm) Weight......................................................................0.52 kg SAFETY INFORMATION • Install the unit near the AC outlet and where the AC plug can be easily reached. • Where the MAINS plug is used as the disconnect device, the disconnet device shall remain readily operable. • Place the set on a hard and flat surface so that the system does not tilt. • If you do not intend to use the set for a long time, withdraw the power plug from the wall outlet. In addition to this, it is advisable to remove the battery from the clock radio. This will prevent any danger of leakage and the clock radio will not be damaged. • Do not expose the set, batteries to humidity, rain, sand or excessive heat caused by heating equipment or direct sunlight. • The apparatus shall not be exposed to dripping or splashing. • Adequate ventilation with a minimum gap of 15cm between the ventilation holes and surrounding surfaces is necessary to prevent heat build-up. • The ventilation should not be impeded by covering the ventilation openings with items, such as newspapers, table-cloths, curtains, etc.. • No objects filled with liquids, such as vases, shall be placed on the appartus. • No naked flame sources, such as lighted candles, should be placed on the apparatus. • To clean the set, use a soft, slightly dampened chamois leather. Do not use any cleaning agents containing alcohol, ammonia, benzene or abrasives as these may harm the housing. • Battery shall not be exposed to excessive heat such as sunshine, fire or the like. CAUTION Use of controls or adjustments or performance of procedures other than herein may result in unsafe operation. This set complies with the radio interference requirements of the European Union. TROUBLESHOOTING If a fault occurs, first check the points listed below before taking the set for repair. If you are unable to remedy a problem by following these hints, consult your dealer or service center. WARNING: Under no circumstances should you try to repair the set yourself, as this will invalidate the warranty. Do not open the set as there is a risk of electric shock. Problem – Possible Cause • Remedy No sound/power – Volume not adjusted • Adjust the volume Occasional crackling sound during FM broadcast – Weak signal • Adjust the position of the Pigtail Continuous crackling/hiss disturbance during MW broadcast – Electrical interference from TV, computer, fluorescent lamp, etc. • Move set away from other electrical equipment The alarm does not function – Alarm time not set and or alarm mode not selected • Set the alarm time and / select alarm mode – Volume too low for RADIO • Adjust the volume – Radio alarm not adjusted to radio station •Tune to a radio station ENVIRONMENTAL INFORMATION We have reduced packaging to the minimum for easy separation into two materials: paper and cardboard. Your set consists of materials which can be recycled if disassembled by a specialized company. Please observe local regulations on the disposal of packing materials and old equipment. Disposal of your old product Your product is designed and manufactured with ...