P 7 8 9 0 4 5 6 • 1 2 3 = ABCD 7 8 9 0 4 5 6 • 1 2 3 = A • After you perform an operation in any mode, pressing C returns to the Timekeeping Mode. • An input tone sounds each time you press a button. You can switch the confirmation tone on and off in the Calculator Mode. Alarm Mode 7 8 9 0 4 5 6 • 1 2 3 = Stopwatch Mode P 7 8 9 0 4 5 6 • 1 2 3 = 7 8 9 0 4 5 6 • 1 2 3 = Timekeeping Mode AB General Guide • You can use the Remote Control functions while in the Timekeeping Mode. • Press C to cha

•Replace the batteries at least once a year, even if the current batteries are working properly. •Never charge the batteries that come with the clock. •Should the batteries ever leak while in the clock, wipe out the fluid with a cloth, taking care not to let any get onto your skin. •The batteries that come with the clock lose some of their power during transport and storage. •Never mix old and new batteries, or batteries of different brands. Alarm Time Press to change the alarm time setting ().P

Be sure to remove the sticker before using the clock. • Depending on the clock model, its configuration may differ somewhat from that shown in the illustration. SETTING THE TIME 1. Slide the selector to TM SET . 2. Press HR to increase the hour digits and MIN to increase the minutes digits. Holding down either button changes its setting at high speed. •Though the seconds are not displayed, they reset to 00 when you press MIN . 3. After you set the time, change the selector to NORMAL . USING THE

The face illuminates for the first 5 seconds of the alarm operation as well. The alarm tone alternates between three levels. You can also use the Alarm Mode selector 6 to select the snooze alarm feature. Setting the Alarm Time 1. Slide the Mode switch 5 to “AL”. This causes the alarm time setting to flash on the display. 2. Use the 12 • 24/YEAR button 2, MIN/ DATE button 3, and HR/MONTH button 4 to set the alarm time. Holding down the MIN/DATE button 3 or HR/ MONTH button 4 changes the correspon

Whenever the stopwatch stops running, the "STOP" indicator will be ON. Press the button [START/STOP] to start the stopwatch. As it runs, the current elapsed time is shown on the lower line. {000} 0: 00' 00" 00 SPLIT 0: 00' 00" 00 LAP RUN 0: 03' 35" 52 To view the current split / lap time, you can press [LAP/SPLIT]. {001} 0: 10' 43" 35 SPLIT 0: 10' 43" 35 LAP RUN 0: 10' 43" 35 The number of split/lap times is shown on the upper left corner. The corresponding split and lap times are displayed on t

Be sure to remove the sticker before using the pedometer. • Depending on the model of your pedometer, its configuration may differ somewhat from that shown in the illustration. GENERAL GUIDE 11111 MODE button 22222 RESET button Hold down the RESET button for about three seconds to reset the displayed number of steps, distance, and calorie values to zero. 33333 Front panel 44444 Back panel 55555 Clip OPENING THE PEDOMETER PANELS Holding the front and back panels of the pedometer, release the catc

Take the time to carefully read these operating instructions. USER INSTRUCTIONS Channel number/ Outside temperature/Humidity A Graphical Indoor thermometer Weather report symbols Clock; Clock Alarm Inside temperature; Outside temperature/ humidity display; Min/ Max record; Temperature Alarm Temperature trend indicator Outside channel Features: Block with main display: • Clock with choice of time display format (12 or 24 hour) • Indoor and outdoor temperature display • Graphical displa

In some areas, magnetic declination can be considerable, so it is a good idea to check for declination on your map or on the Internet. To adjust the compass declination angle, go to Compass Mode and hold down ADJ button for 3 seconds, and the Compass Homing Mode is displayed. Press MODE button until you get into Declination Setting Mode displayed as ‘DEC’. Press UP or DOWN button for desired value then just press ADJ button to save settings and exit the mode. Declination is sometimes measured as

TIME • WATER RESISTANT TO 330 FEET OR 100 METERS • NIGHT VISION™ BACKLIGHT To operate your FreeStyle® watch, please follow these instructions: The term “MODE” refers to the function status of the watch.) Normal time mode shows hours, minutes, seconds, and the day of the week. To set time, see instructions below: HOW TO SET NORMAL TIME, CALENDAR & 24-HR. TIME FORMAT From “Normal Time” mode, press and hold MODE button; alarm time will flash. Press MODE button again; seconds digits will flash. Pres

Press and Hold to Reset. #998-310A In the classroom, the Time Timer can be used to set time limits, measure the duration of activities and train students to make better use of available time. Use the Time Timer products to: • Time standardized tests • Monitor math and writing speed tests • Measure study periods and lunch periods • Regulate computer time • Administer duration drills • Show time left to play, get ready or clean up Using Time of Day and Alarm Press MODE (lower left) button until th