Évaluations - 1, GPA: 3
(
)
)
|
Facilité d'utilisation
WARNING: Make sure the Console is located far enough from the TV and from other people, animals, and objects to avoid striking them when you swing the Paddle. MODEL 8028 P/N 82349400 Rev.A For 1 or 2 players / Ages 8 and up INSTRUCTION MANUAL To exit demo mode,press the Restart or Enter button. With Radica Play TV Ping Pong™, you'll play against the pros right in your own living room. Warm up with a challenging Traditional match against another player or a computer opponent. Or, try your hand against FireBalls, ScrewBalls and other exciting action in the Arcade. BATTERY INSTALLATION Locate the battery compartment door on the bottom of the console and on each paddle. Loosen the screw with a Phillips screwdriver. Remove the battery compartment door. Insert four "AA" batteries (we recommend alkaline) as indicated inside the console and two “AA” batteries as indicated in each paddle. Replace the battery compartment door and tighten the screw. ADULT SUPERVISION IS RECOMMENDED WHEN INSTALLING BATTERIES. CONNECTING RADICA PLAY TV PING PONG™ TO YOUR TV OR VCR CONNECTING TO A TV NOTE: To connect Play TV Ping Pong™ directly to a TV, the TV must be equipped with audio and video input jacks. They are commonly found on the front of the TV near the contrast, color, and picture adjustment controls, or on the rear of the TV near the antenna and cable/satellite jacks. If your TV does have audio and video input jacks, insert the yellow video plug into the video-in (yellow) jack on your TV; the white audio plug into the left audio-in (white) jack; and the red audio plug into the right audio-in (red) jack. Then set the TV to the appropriate video input mode (see your TV operating manual for details). Please Note:If your TV is not stereo, you can either plug the white audio plug into the audio-in jack and leave the red audio plug disconnected, or, if you would like to hear sounds from both the left and right audio channels, you can use a 2 into 1 audio cable (available at your local electronics store) to connect both the white and red plugs to the single audio-in jack. If your TV does not have audio and video input jacks, you may connect Ping Pong through a VCR connected to your TV. CONNECTING TO A VCR To connect Play TV Ping Pong™ to the VCR connected to your TV, insert the yellow video plug into the video-in (yellow) jack on your VCR; the white audio plug into the left audio-in (white) jack; and the red audio plug into the right audio-in (red) jack. Then set the TV and VCR to the appropriate video input modes (see your VCR and TV operating manuals for details). Please Note:If your VCR is not stereo, you can either plug the white audio plug into the audio-in jack and leave the red audio plug disconnected, or, if you would like to hear sounds from both the left and right audio channels, you can use a 2 into 1 audio cable (available at your local electronics store) to connect both the white and red plugs to the single audio-in jack. ADULT SUPERVISION IS RECOMMENDED WHEN CONNECTING CABLES TO A TV AND VCR. GETTING STARTED IMPORTANT SAFETY NOTE: Before beginning game play, be sure to place your serving wrist through the Safety Strap on the bottom of your Paddle. • Place the Console on a table in front of the TV. • When serving and returning the ball, you will need to stand in Power Restart Pause BUTTON FUNCTIONS POWER -Turns the power on and off. RESTART -Restarts the game at any time. PAUSE -Pauses the game during game play. To resume game play, press this button again. ENTER -Locks in the highlighted selection in the Game Set-Up Screen. UP ARROW -Highlights the previous selection in the Game Set- Up Screen. DOWN ARROW -Highlights the next selection in the Game Set- Up Screen. PADDLE BUTTON -Press and release the Paddle Button to serve the ball. RESET -Press this button, using an object such as a pen or straightened paper clip, to reset the game in the event of a malfunction. Paddle Button PLAYING RADICA PLAY TV PING PONG™ • If Play TV Ping Pong™ is connected to your TV, turn on the TV and set it to the appropriate video input mode (see the CONNECTING TO A TV section of this manual). • If Play TV Ping Pong™ is connected to your TV through a VCR, turn on the TV and VCR and set both to the appropriate video input modes (see the CONNECTING TO A VCR section of this manual). • Press the Power button. You will see a brief start-up animation. • Press the Enter button to go to the Game Set-Up screen. SETTING YOUR GAME PREFERENCES Game Mode • Use the Up and Down Arrow buttons to select Traditional or Arcade game play. • Press the Enter button to lock in your selection. Level • Use the Up and Down Arrow buttons to select Beginner, Intermediate or Advanced. • Press the Enter button to lock in your selection. Number of Players • Use the Up and Down Arrow buttons to select the number of players: Player One vs. Computer, Player One vs. Player Two, or Players One and Two vs. Computer. • Press the Enter button to lock in your selection. Player Se...