Log:
Téléchargements : 4   Taille : 459 kb   Fabricant : Follett  
Catégorie : Dispensers
@name

5. Icemaker related problem. 6. Faulty or disconnected wiring. 1. Check switch and replace if necessary. 2. Check switch and replace if necessary. 3. Replace bin thermostat. 4. Replace transformer. 5. Refer to Icemaker Operation and Service Manual for diagnosing. 6. Check for power and bin signal on icemaker PC board. 15 Symptom Carbonator pump not turning on. Carbonator pump is not turning off. Carbonation system is not carbonating. Carbonation system is producing excessively carbonated beverag

Téléchargements : 10   Taille : 249 kb   Fabricant : Carrier  
Catégorie : Dispensers
@name

1 - 07KA Water-Cooled Condensing Unit *Factory charge. Refer to Refrigerant Charging, page 3, for charging details. tUse Carrier PP-33-2, Texaco Capella Bl or Suniso 3G Dual Inhibited oil. NOTE: High and low pressurestats cut-in and cutout points are not adjustable. Table 2 - Electrical Data (60-Cycle) COND UNIT 07KA VOLTS PHASE BRANCH CIRCUIT NDSV LRA FLA MAX KW WSA Wire Size (AWG No) Max Ft Wire Wire Size (AWG No) Max Ft Wire Fuse Amp* 002310 230 1 230 49 0 12 0 2 75 15 2 12

Téléchargements : 5   Taille : 230 kb   Fabricant : U-Line  
Catégorie : Dispensers
@name

No additional clearance around sides, top or rear of unit for ventilation. Do not obstruct front grille. Stainless steel model • Offers a bold commercial-style stainless steel handle, stainless steel framed glass door with a black "cap" on the top and bottom of the door • Must order right- or left-hand hinged Tinted, thermal glass door Protects wine from potentially harmful ultraviolet light rays Black vinyl-clad cabinet • Textured look, more resistant to scratching, peeling or flaking • Blac

Téléchargements : 13   Taille : 4 mb   Fabricant : Nuvo  
Catégorie : Dispensers
@name

(See troubleshooting for details.) G. Always remove all bottles before relocating your wine cellar. HARDWARE KIT C B A Cam Cap x 20 (x24)* Hex Wrench x 1 Hex Bolt x 14 D F E Leg x 4 Cam x 20 (x24)* Cam Pin x 20 (x24)* H G In Cooling Unit Box Hex Bolt (Flange) x 2 Panel Insulation Strip x 1 *NOTE : Hardware quantities for Model 220 are indicated in parenthesis. STEP 1 : PANEL PREPARATION CAUTION : 1. Watch for sharp staples on boxes. 2. DO NOT STEP ON PANELS 3. The manual will give a recommended

Téléchargements : 1   Taille : 1 mb   Fabricant : Follett  
Catégorie : Dispensers
@name

Before calling for service: • Check that there is ice in dispenser bin area • Check that all switches and circuit breakers are on • Check that congealed cubes are not causing a jam • Check that all drains are clear Symptom Possible causeSolution1. Does not dispense ice a. Faulty dispense gate b. Faulty dispense solenoid c. Power switch off or faulty d. Faulty dispense switch e. Wheel motor malfunction f. Drive chain off g. Sprocket key missing a. Replace dispense gate b. Replace dispense solenoi

Téléchargements : 4   Taille : 1 mb   Fabricant : Follett  
Catégorie : Dispensers
@name

Note: A 15% restocking charge will be deducted from the credit. If the cost to return the product to stock exceeds 15%, the actual cost will be deducted. 2 Table of contents Before you begin 4 Specifications 5 Field wiring 6 Installation 8 Installing freestanding dispensers 8 Installing wall mount dispensers 10 Installing Satellite-fill™ icemakers 12 Installing top mount icemakers 12 User information 14 Cleaning and sanitizing procedures 14 Service Information 16 Wiring diagram – lever models 16

Téléchargements : 0   Taille : 1 mb   Fabricant : Follett  
Catégorie : Dispensers
@name

Apply a thick bead, approximately. 1/4" (6mm) diameter, of NSF listed silicone sealant (Dow- Corning RTV-732 or equivalent) 1/4" (6mm) inside marked outline of dispenser. 11. Carefully position dispenser on counter. 12. Remove four screws securing splash panel to front of dispenser and gently lay splash panel on counter. (Water line to solenoid valve can be disconnected from water inlet valve by pushing on ring at end of inlet fitting while pulling on tubing.) 13. Secure dispenser to counter wit

Téléchargements : 1   Taille : 1 mb   Fabricant : Follett  
Catégorie : Dispensers
@name

Replace splash panel. 14. Plug dispenser power cord into 20 amp rated NEMA 5-20 wall socket. 15. If dispenser is equipped with SensorSAFE remove protective plastic coating form dispense sensor labels. 16. Turn on power and bin signal rocker switches and test operation. 17. Clean and sanitize icemaker following instructions in icemaker manual. 18. Remove dispenser hopper access lid and clean and sanitize dispenser according to instructions on page 14. 19. Replace front cover and secure with screw

Téléchargements : 3   Taille : 2 mb   Fabricant : U-Line  
Catégorie : Dispensers
@name

Table 1 Serve a: Before a: DRY wine SWEET wine WHITE wine RED wine YOUNG wine OLD wine LIGHT-BODIED wine FULL-BODIED wine Any step back in quality will be noticed. If a fine wine is tasted prior to a lesser wine, many of the fine wine’s subtle qualities may be missed. Common Food and Wine Matches Table 2 Foods Wines Fish, Shell Fish, Crab, Oysters Dry White Wines, Light Sparkling or Extra Dry Champagne Beef, Venison Full-Bodied Red Wines Pork, Veal, Lamb and Poultry Light-Bodied Red Wines Fruit

Téléchargements : 6   Taille : 774 kb   Fabricant : Cornelius  
Catégorie : Dispensers
@name

Light Tube Replacement WARNING! DISCONNECT THE POWER CORD BEFORE ATTEMPTING LIGHT TUBE REPLACEMENT. Failure to do so may result in an electrical shock that could severely injure you. This product uses two, 6 watt light tubes to illuminate the interior of the wine chiller. The light tubes are very reliable electrical components, but should either or both light tubes not function properly, please call the dealer you purchased your wine chiller from for replacement light tubes. Use only original eq





catégories