Log:
Téléchargements : 0   Taille : 596 kb   Fabricant : Metra Electronics  
Catégorie : Perceuses et shuropopverty
@name

INSTALLATION INSTRUCTIONS FOR PART 99-7606 INSTALLATION INSTRUCTIONS FOR PART 99-7606 Torx T-10 Driver • Small Flat Blade Screwdriver • Phillips Screwdriver KIT FEATURES • DIN Radio Provision with pocket • ISO Radio Unit Provision with pocket • Double DIN Radio Provision • Stacked ISO Head Units Provision A) Radio Housing • B) ISO Brackets • C) ISO Trim Plate • D) Double DIN Brackets • E) Double DIN Trim Plate • F) Pocket • G) (6) Panel Clips • H ) Two Sided Tape (Not Shown) KIT COMPONENTS 99-76

Téléchargements : 1   Taille : 428 kb   Fabricant : Metra Electronics  
Catégorie : Perceuses et shuropopverty
@name

THE WORLD’S BEST KITS.™ a 1-800-221-0932 Q © COPYRIGHT 2004 METRA ELECTRONICS CORPORATION 95-2 no TABLE OF CONTENTS Dash Disassembly 1BB7-2001 Cadillac Catera ............................. 1 1BB6-1BBB Cadillac Devllle (Column Shift Only) ............. 1 Kit Preparation 1BB7-2001 Cadillac Catera.............................2 1BB6-1BBB Cadillac Deville (Column Shift Only) ............. 2 Kit Assembly 1BB7-2001 Cadillac Catera / 1BB6-1BBB Cadillac Deville ( Column Shift Ony) DDIN Hea

Téléchargements : 0   Taille : 281 kb   Fabricant : Metra Electronics  
Catégorie : Perceuses et shuropopverty
@name

. . ..1 Kit Preparation -Display Unit Assembly . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .2 Kit Assembly -DIN Mount Radio Provision with Pocket. . . . . . . . . . . . . . . . . . . . . . . .3 -ISO Mount Radio Provision with Pocket. . . . . . . . . . . . . . . . . . . . . . . . 4 Final Assembly ...........................................5 *Note: Refer also to the instructions included with the aftermarket radio. KNOWLEDGE IS POWEREnhanceyour installation and fabricatio

Téléchargements : 0   Taille : 250 kb   Fabricant : Metra Electronics  
Catégorie : Perceuses et shuropopverty
@name

Locate one of the Left Brackets and mount it to the “L” side of the Pocket with (2) #6 x 1/4" Phillips Flat Head Screws. Next locate one of the Right Brackets and mount it to the “R” side of the Pocket with (2) #6 x 1/4" Phillips Flat Head Screws. (Figure A) 3 Mount the factory brackets to the shaded bosses (Fig. B2) with (4) #8 x 1/4" Phillips Pan Head Screws supplied and mount the entire assembly to the sub-dash. (Figure B) 1 98-8999 POCKET ASSEMBLY SUBARU POCKET 1 Disconnect the negative





catégories