Évaluations - 0, GPA: 0
(
)
)
|
Facilité d'utilisation
The oven will heat until this time is up. Self-cleaning During the self- cleaning function, the oven heats to about 500 °C. In this way, baking and cooking remains are burned and only ash remains have to be cleaned from the oven. There are three cleaning levels available. Level Cleaning level Duration ‚ mild approx. 1 hour, 15 minutes . medium approx. 1 hour, 30 minutes „ intense approx. 2 hours The more intense and old the dirt, the higher the self cleaning level used. The inside of the oven only has to be cleaned once every two or three months. Complete cleaning requires approximately 2.5 - 4.7 kilowatt-hours. Important notes For your safety, the oven door locks automatically. The oven door cannot be opened again until the cooking compartment has cooled slightly and the padlock symbol for the locking mechanism disappears. The oven light in the cooking compartment does not come on during Self-cleaning. : Risk of burns! ¦ The cooking compartment will become very hot during the Self-cleaning cycle. Never open the appliance door or move the locking latch by hand. Allow the appliance to cool down.Keep children at a safe distance. ¦ The appliance will become very hot on the outside during the Self-cleaning cycle. Never touch the appliance door. Allow the appliance to cool down. Keep children at a safe distance. : Risk of fire! The appliance will become very hot on the outside during the Self- cleaning cycle. Never hang flammable objects, e. g. tea towels, on the door handle. Do not place anything against the front of the appliance. Before using the self-clean function The oven must be empty. Remove accessories, pans, guides or left and right hand side rails. See the Cleaning and Care chapter to release the guides or left and right hand side rails. Clean the oven door and the side surfaces inside the oven around the area with seals. : Risk of fire! ! The remains of food and grease as well as roasting juices can catch fire. Use a damp cloth to clean the inside of the oven and the accessories that will be cleaned inside the oven. Cleaning of the accessories The wire shelves or left and right hand side rails are not suitable for self cleaning. Remove these from the oven. For optimum cleaning of the oven interior, it is recommended that the self- clean function is not used with the trays. However, with the accessory support, the universal deep enamel tray or the flat enamel oven tray can also be cleaned using the self- clean function. Only clean one accessory at a time. The shelf should not be cleaned using the self-clean function. If your oven does not have this support, it can be purchased from the Technical Assistance Service or over the Internet by quoting part number 466546. The accessory support is inserted to the right and left. Use water to clean food remains, oil and roasting juices from the accessories. Place the universal deep tray or the flat oven tray on the support. : Significant health risks! Do not place non-stick baking tins or trays in the oven during self-cleaning. The intense heat removes the non-stick surface and creates toxic gases. Setting Once the cleaning level has been selected, set the oven. 1. Select the self-cleaning function with the function control knob V . 2. Set the required cleaning level using the @ or Asensors. The display panel will show the cleaning level and the x symbol. Self-cleaning starts within a few seconds. The oven door locks shortly after the function has started. The display panel displays H. Only when the H symbol turns off can the oven door be opened again. Self- cleaning has ended. The display panel will show ‹‹ : ‹‹ . The oven will stop heating. Turn the function control knob to the zero setting. The oven switches off. The oven door can be opened again when the H symbol on the display panel turns off. Changing the cleaning level The cleaning level cannot be changed once it has started. Stopping the self- cleaning Turn the function control knob to the zero setting. The oven switches off. The oven door can be opened again when the H symbol on the display panel turns off. Delaying the end time The oven allows you to programme the self-cleaning end time. Self-cleaning can therefore be programmed at night for example, leaving the oven free for use during the day. Programme as described in section 1 and 2. Before starting the self- cleaning, press the 0 sensor three times and delay the end time with the @ or A sensors. The oven is set to standby. The display panel will show the cleaning level and the y symbol. When self- cleaning starts, the cleaning level and the x symbol are shown. The y symbol switches off. Viewing the time settings To view the duration of the cleaning level or the end time of the self- cleaning press the 0 sensor repeatedly until the required symbol lights up. The corresponding value will be shown for a few seconds on the display panel. After using the self-clean function Once the inside of the oven has cooled, clean the ash remains using a damp cl...
Ce manuel est également adapté pour les modèles :Fours - 3HB556XM/01 (1.24 mb)
Fours - 3HB557XM/01 (1.24 mb)