• Level 1: Only DVD softwares intended for children can be played back, with those intended for adult and general use prohibited. T TTo Chang o Chango Change the P e the Pe the Pass assassw wwor orord f d fd for P or Por Parental Contr arental Contrarental Controls olsols You can change your password for parental controls. Follow the steps 1) to 3) in the “CUSTOM Menu” section on page 20. DVD Functions SETUP PARENTAL PASSWORD Enter current password. 44 • Record the password in case you forget it. • If you forget the password, press 4, 7, 3, 7 at step 4, then enter your new pass- word. • Password will be cleared and parental levels will be set to ALL. or 4411 55 or Select “CHANGE” PARENTAL LEVEL ALL 77 SETUP 66 ENTER Enter your new four-digit password (except for 4737) ENTER To exit the menuEnter your desired four- digit password (except for 4737) To AL) to the Default Setting SETUP QUICK CUSTOM INITIALIZE Select “YES” ST SETUP INITIALIZE Initialize? NO YES or SETUP To exit the menu x2 (twice) HintHint • When you cancel to initialize at step 3,select “NO”. ENTER SETUP PARENTAL PASSWORD Please enter a 4-digit password. SETUP QUICK CUSTOM INITIALIZE 2 31 5 64 8 97 0 2 31 5 64 8 97 0 PARENTAL menu –22– EN Information Troubleshooting Guide If this unit does not perform properly when operated as instructed in this Owner's Manual, check this unit consulting the following checklist. PROBLEM CORRECTIVE ACTION V C R D V D No power. • Make sure the power plug is connected to an AC outlet. • Make sure the power is turned on. This unit does not respond to the remote control. • Check if the power plug is connected to an AC outlet. • Check the batteries in the remote control. • Aim the remote control directly at the remote sensor. If necessary, remove all the obstacles between the sensor and the remote. • You have to be within 23 feet of this unit. • Check if the right mode is selected. If it’s not in the right mode, press the DVD or VCR buttons, whichever you need, on the remote control. • Check if a cassette tape is in this unit. • Tune your radio to an empty AM station so that you hear a lot of noises. Turn the volume up, then. If you hear some signal sound from the radio in response to your pressing buttons on the remote, the remote control is working. V C R Timer recording is impossible. • Make sure the timer recording is set correctly. • Make sure the TIMER REC light appears on the DVD/VCR. If not, press the SUBTITLE/ T-SET button. • Make sure the VCR clock is set correctly. Cannot go into Record mode. • Make sure the tape has a safety tab. If needed, cover the hole with cellophane tape. •Activate this unit in VCR mode. Press the VCR button on the remote control so that the green VCR OUTPUT light is lit. Playback picture is partially noisy. • Adjust tracking control for a better picture by pressing the CHANNEL buttons on the DVD/VCR or the SKIP/CH.(K/L) buttons on the remote control. ( ) Cannot view a tape but the audio is OK. • Head cleaning may be necessary. Refer to “AUTO HEAD CLEANING” . • Make sure the VCR is not in the Menu mode. No, or poor, playback picture. • Change the RF output channel to CH4. Then select the same channel on the TV. • Fine tune your TV. TV programs cannot be seen normally. • Re-check the ANT. IN and ANT. OUT connections. See pages 1 and 6. • Press the VCR/TV button. • Press the VCR button on the remote control to activate it in the VCR mode. Check if the green VCR OUTPUT light is lit. Then, set it to the TV position by pressing the VCR/TV button. Video or color fades in and out when making a copy of a video tape. • You cannot copy a copyrighted video tape. You are experiencing copy guard protection. Cannot remove the tape. • Check if this unit is in the VCR mode. If not, press the VCR button on the remote control to switch the mode. D V D No picture. • Connect the video cables firmly. • Insert a correct video disc that plays on this unit. • Press the DVD button on the remote control. Check if the DVD OUTPUT light is lit. Then try other DVD features. Disc cannot be played. • Insert the disc. • Clean the disc. • Place the disc correctly with the label side up. • Cancel the parental lock or change the control levels. • Handle a disc with special care so that it does not have fingerprints, scratches, or dusts on its surface. No sound. • Connect the audio cables firmly. •Turn the power of the audio component on. • Correct the audio output settings. • Correct the input settings on the audio component. No DTS audio is output. • This unit does not support DTS audio. This is not a malfunction. Distorted picture. • Connect this unit directly to the TV. • There are some cases where pictures may be slightly distorted, and those are not a sign of a malfunction. • Although pictures may stop for a moment, this is not a malfunction. Audio or subtitle language does not match the set up. • The selected language is not available for audio or subtitles on the DVD. This is not a malfunction. The ...
)
