Évaluations - 3, GPA: 3.7 ( )

Fabricant : JVC Taille : 1.69 mb Nom Fichier : Langue d'enseignement:

To remove screen, press PLAY on the remote or unit. • Use “dry” type head cleaning cassette only. (Part No. NV-TCL30PT is recommended.) • Follow cleaning tape directions carefully. Excessive use of tape can shorten head life. • If head clog symptoms persist, contact your nearest Factory Service Center or authorized Service Center. (See Page 41.) VIDEO HEADS MAY NEED CLEANING PLEASE INSERT HEAD CLEANING CASSETTE OR REFER TO MANUAL END;PLAY KEY Do “One Time Setup” steps on page 8. DST (Daylight Saving Time) Specifications Unit auto adjusts clock for DST (Daylight Saving Time.) Spring (First Sunday in April) DST:ON -» Sets clock ahead one hour. 1:00 a.m. 2:00 a.m. Display Picture Tube: NORMAL TIME DAYLIGHT SAVING TIME 3:00 a.m. 4:00 a.m. Autumn (Last Sunday in October) DST:ON -4 Turns clock back one hour. DAYLIGHT SAVING TIME 1:00 a.m. 2:00 a.m. NORMAL TIME 1:00 a.m. 2:00 a.m. If your area does not observe Daylight Saving Time, select DST:OFF. Keep these time changes in mind when programming the unit for timer recordings. 13 inch (VV-1300/1310W) 20 inch (VV-2000) measured diagonal 90 ° deflection Picture Tube 2 rotary heads helical scanning system 1 track (Normal) VHF 2 - 13, UHF 14 -69 Midband A through 1(14- 22) Superband J through W (23 - 36) Hyperband AA - EEE (37 - 64) Lowband A-5 - A-1 (95 - 99) Special CABLE channel 5A (01) Ultraband 65- 94, 100 - 125 120 VAC, 60 Hz Approx. 69 watts (VV- 1300/131OW) Approx. 110 watts (VV-2000) Power Off Approx. 4.5 watts EIA Standard NTSC color 1 pieces 5°C - 40 °C (41 °F - 104 °F) 10 % - 75% 12 kg (26.4 lbs.) (VV-1300/1310W) 23 kg (50.6 lbs.) (VV-2000) 15-3/16” (W) X 15-3/16” (H) XI4-3/4" (D) 386 (W) X 385 (H) X 374 (D) mm (VV-1300/1310W) 20-5/16" (W) X 19-7/8” (H) X18-11 /16” (D) 515 (W) X 505 (H) X 474(D) mm (VV-2000) Note: Designs and specifications are subject to change without notice. VCR Video Recording System: Audio Track: Tuner Broadcast Channels: CABLE Channels: General Power Source: Power Consumption: Television System: Speaker: Operating Temperature: Operating Humidity: Weight: Dimensions: 35 For Your Information VCR Status & Clock Display Blue Screen Display To display or remove the overlay. Press DISPLAY. Function Status Channel Caption Current Time Rec Time Remaining (OTR mode only see-- page 13.) REC 0: 25 12:00PM ABC -0:12:34-SP- 12/27/1999 MON 12:00PM- 1:OOPM СН 08 ABC MOVIE MEMORIAL MOVIE Counter Tape Speed Whenever a blank section of a tape comes up in Play mode, or when the selected channel has no broadcast signal with the “Weak Signal Display ON/OFF” (see page 28) set to “OFF, the TV screen will turn solid blue. Time Stamp Data (See page 26, 27.) Channel & Function Display When a function button is pressed (PLAY, FF, etc.) or you change channels, the unit mode or channel number will be displayed. (Some station names may also appear if Channel Caption is set. See pages 24, 25.) Warning and Instruction Displays operation or provide further instructions. OSD Caution Page NO CH FOUND PLEASE CHECK ANTENNA CABLE CONNECTION THEN PUSH CH UP KEY AGAIN • If no active channels are found for CHANNEL MEMORY... 7 PLEASE SET CLOCK BEFORE PROGRAMMING • If you attempt to set or review a Timer Recording or set the On-Timer and the Clock is not set... 8, 9, 34 CHECK CASSETTE RECORD TAB • If you press REC, and a cassette is inserted with no record tab... 6, 13 TO CANCEL TIMER REC HOLD DOWN STOP KEY FOR APPROX 3 SEC • If you press STOP during a Timer Recording... 15 NO CASSETTE PLEASE INSERT A CASSETTE • If you press PLAY, FF, REW, or REC without a cassette inserted... 12, 13 PLEASE PREPARE FOR TIMER REC • If the unit is not in Stop mode or a cassette with record tab is not inserted two minutes before a Timer Recording is about to begin... 14, 15 VIDEO HEADS MAY NEED CLEANING PLEASE INSERT HEAD CLEANING CASSETTE OR REFER TO MANUAL END: PLAY KEY • If head cleaning becomes necessary while playing back a tape... 35 VCR LOCK ACTIVATED • If you press a function button other than STOP/EJECT or POWER while the unit is in VCR Lock mode... 28 36 For assistance, call 1-800-211-PANA(7262) Spanish Quick Use Guide/Guía para rápida consulta Conexión de la antena externa Desenganche la antena del televisor o de la videograbadora que tuviera anteriormente y conéctela a la parte trasera del registrador Combinación de VCR/TV, como se muestra en el diagrama. Si el sistema de su antena tiene conductores UHF y VHF separados, usted necesita un mezclador de banda UHF/VHF (no viene con el equipo.) ADVERTENCIA: Al utilizar cables coaxiales RF del “Tipo tuerca”, solo debe apretarse con los dedos. Si se aprieta demasiado los cables pueden resultar dañados. (Plano) Cable bifubular de 300 ohmios Mezclador de banda UHFVHF (no está incluido) (Redondo) Cable coaxial de 75 ohmios desde la antena Transformador de 300-75 ohmios (no está incluido) (Plano) Cable bifubular de 300 ohmios Parte trasera de la combinac...

Téléchargez votre

Pour télécharger, entrez 2 chiffres :