Évaluations - 2, GPA: 4 ( )

Fabricant : Lennox Hearth Taille : 57.33 kb Nom Fichier : Langue d'enseignement:

Then tilt top of door toward vertical position making sure that all Pins and Door Guides are inside Track. Finally, slide Top Pin along Top Retainer Clip until Top Pin snaps into Top Retainer Slot. Repeat procedure for left door. Top (Narrow) Door Guide (Wide) Door Guide Retainer Clip Bottom BottomRetainer Handle Clip Pin Figure 3 Figure 2 NOTE: DIAGRAMS & ILLUSTRATIONS NOT TO SCALE ADJUSTMENT FOR DOOR ALIGNMENT ADJUSTMENT FOR DOOR ALIGNMENT If doors appear to close in correct position but do not latch (both doors do not stay closed), then there is a misalignment between the doors and the Center Wedge Clip. The Center Wedge Clip is located in the center of the bottom Track. In order to stay closed, the left and right doors must meet in the Middle of the Center Wedge Clip. To adjust doors, first loosen, but DO NOT remove the Phillips Screw that holds the Retainer Clip to the frame. Move door to desired position then tighten screw. Repeat procedure for other Retainer Clips as needed. Operate doors to check alignment and repeat procedure if necessary. GENERAL OPERATING PRECAUTIONS AND INSTRUCTIONS CAUTION: THESE GLASS DOORS ARE LISTED ONLY FOR USE WITH THE LENNOX FIREPLACE OR APPLIANCE MODELS SHOWN. USE ON ANY OTHER FIREPLACE OR APPLIANCE MAY CONSTITUTE A POTENTIAL FIRE HAZARD. • Avoid building extremely large fires as the tempered glass could become damaged. • Use fireplace tools carefully to avoid striking the glass. • Keep wire mesh screens closed during fireplace use. • The fireplace flue damper must remain open until fire is completely out. • Assure wood and embers are well within the confines of the grate area and well away from the glass doors. • Keep wire mesh screens closed during fireplace use. • Keep glass doors closed at night when retiring to minimize the loss of heated room air up the vent. CAUTION: THE FRONT-OPEN FIREPLACE OR APPLIANCE SHOULD ONLY BE OPERATED WITH THE GLASS DOORS FULLY OPEN OR FULLY CLOSED (SEE FIGURE 4). CAUTION: GLASS AND METAL FRAMES GET HOT — ALWAYS USE HANDLES TO OPEN AND CLOSE THE DOORS. To remove the doors, open door all the way until glass panes are back to back. While pushing down on door, push up on Top Retainer Clip with finger to free Top Pin and rotate top of door toward center of frame. Carefully remove door. Fully Open or Fully Closed Front-Open Systems Figure 4 CLEANING NEVER CLEAN THE GLASS WHEN THE DOORS ARE HOT. DO NOT USE AMMONIA OR ANY AMMONIA BASED GLASS OR HOUSEHOLD CLEANER TO CLEAN THE GLASS OR THE DOOR FRAME. AN AMMONIA BASED CLEANER WILL DAMAGE THE FINISH. Remove dirt and grime from the doors using a clean dampened towel followed by wiping with a dry towel. To remove stubborn stains from the doors, use a mild soap solution and towel to gently scrub away stain. Take care not to scratch the glass surface. Do not use abrasive cleaners. IMPORTANT These glass doors utilize tempered glass which is designed for use with high temperatures but can unexpectedly shatter. DO NOT SIT CLOSE TO THE GLASS. T...

Téléchargez votre

Pour télécharger, entrez 2 chiffres :