Évaluations - 2, GPA: 4.5 ( )

Fabricant : Honeywell Taille : 1.63 mb Nom Fichier : Langue d'enseignement:

(Model No. RPWL30XXX series, and RCA901N and RCA902N.) Safety Before proceeding with the installation, please note the following safety warnings: • Always follow the manufacturer’s advice when using power tools and wear suitable protective equipment (e.g. safety goggles) when drilling holes, etc. • Before drilling holes in walls, check for hidden electricity cables and water pipes. The use of a cable/pipe locator is advisable if in doubt. Decorative Wire Free Chimes and Push Checking Pack Contents • Chime • Bell push (for chime kit only) • CR2032 battery for bell push (for chime kit only) • 2 x fixing screws for push (for chime kit only) • 2 x fixing screws for chime • Wall plugs • Adhesive pad (for chime kit only) You will need: • A Phillips screwdriver • A small flat bladed screwdriver • A 1/4-in. (6 mm) masonry drill • 4 X LR14 ‘C’ Alkaline batteries Installation 1. Open the bell push and insert the push battery (CR2032). 2. Open the chime cover. 3. Insert chime batteries (LR14 C size). 4. Operate push. Chime will play the default tune. First icon will illuminate. Note: The bell push (if supplied) is pre- programmed to operate with the chime. Installation 3 FT (1 M) 5. To adjust volume. Installation 6. To change tunes Press push button, chime will play tune, while the icon on chime is flashing, press and release tune button . Press and release button again to cycle through the available tunes until you hear the tune you want. The last tune played will be stored after the icon stops flashing. To confirm, press the push button and chime will play the tune you want. Installation 7. To add new push/reprogram Press and hold the program button l. The icons will illuminate in sequence. Release the program button when icon you choose is illuminated. Operate your new push and the chime will play tune, icon will flash. To change tune, refer to step 6. 8. Unlearn procedure To remove a push from the chime’s memory, press and hold the program button l. Each icon will light in turn. When the icon associated with the push to be un-learned is lit, release the button. Then press and hold down both l and buttons, until a ‘beep’ sound is heard. 9. Recall function A short push of the program button l will flash the icon that was last in use. 10. Mount the bell push Install back cover to wall, use screws provided/adhesive pad. Close the cover. Note: Before final installation adjust distance and position between push and chime to optimize the chime within your environment. Dense walls and metal can reduce range. Installation TOP Wall Type Range Reduction Dry-lined partition wall 10–30% Single-layer brick wall 20–40% Double-layer brick wall 30–70% Metal panel/radiator 90–100% 11. Mount the chime Mounting holes are marked with screw symbol. Clip on the front cover. 12. For stainable covers only Choose your paint, stain or varnish and then apply to the cover. Follow manufacturers’ advice ...

Téléchargez votre

Pour télécharger, entrez 2 chiffres :