Évaluations - 2, GPA: 3.5
(
)
)
|
Facilité d'utilisation
• When the camera is splashed with detergent, soap, hot spring, bath additive, sun oil, sun screen, chemical, etc., wipe it off immediately. • Card and battery are not waterproof. Do not handle with a wet hand. Also, do not insert wet card or battery into the camera. 14 VQT2M30 (ENG) Causes of water leak • When the camera is used in the following conditions, a gap may occur between the camera and the card/battery door or terminal cover, causing water to leak and malfunction. – When there are foreign objects, such as lint, hair, sand, etc., between the card/ battery door or terminal cover and the camera. – When the rubber seal has deteriorated. – When the [LOCK] switch is not closed on the card/battery door and terminal cover. A: Water will leak through the gap formed remove. B: Water C: Terminal cover D: Card/Battery door E: Hair and lint F: Sand and dust G: Crack and deformation H:Fluid (ENG) VQT2M30 15 Caring of the camera after using it underwater 1 With the card/battery door and terminal cover closed, rinse with water, or if it was used in the sea, soak the unit in fresh water in a shallow container for 10 minutes or less. • If you have attached the silicon jacket, be sure to rinse the camera after removing it. • Leaving the camera with foreign objects or saline matter on it may causedamage, discoloration, corrosion, unusual odour, or deterioration. 2 Wipe off the water, and dry the camera by standing it on a dry cloth in a well ventilated shaded area. 3 Confirm there is no water on the camera, and open the card/battery door and terminal cover. 4 Wipe off any water or sand inside the card/battery door and terminal cover with a soft dry cloth. 16 VQT2M30 (ENG) .This unit incorporates a drain design This unit incorporates a drain design, draining water from gaps in the camera [OFF/ON] button and zoom lever etc. As a result of this, bubbles may come out when you soak the unit in water, but it is not a malfunction. • Example of water droplets around card/battery slot. A: Water droplet B:Battery C:Card • Water droplets may attach to the card or the battery when the card/battery door is opened without fully drying the camera after it is used underwater or soaked in fresh water. Be sure to wipe off the water with a soft dry cloth in such cases. • Do not open or close the card/battery door and terminal cover with droplets ofwater still on the camera. The water droplets may seep into the camera, causing condensation or failure. Note • Wipe off the water and dirt on the camera with a dry soft cloth. • Do not leave the camera uncared for more than 60 minutes after using itunderwater. It may cause deterioration of the waterproof performance. • After use at the seaside or under water, make sure that the card/battery door and terminal cover are firmly closed and soak the unit in fresh water in a shallow container for 10 minutes or less. • If the zoom lever, mode dial, or camera [OFF/ON] button do not move smoothly, it may be caused by an adhesion of foreign objects. Using the camera in such a state may cause malfunctions, such as locking up, so wash off any foreign objects by soaking the camera in fresh water. Confirm that the zoom lever, mode dial, and camera [OFF/ON] button move smoothly after cleaning. • After soaking or washing the unit, wipe off water drops with a dry soft cloth and dry the unit in a shaded area which is well ventilated. • Make sure that water is completely drained from the unit after soaking in water by standing the unit on a dry cloth for a while. • Do not dry the camera with hot air from a dryer or similar. Waterproof performance will deteriorate due to possible deformation. • Do not use chemicals such as benzine, thinner, alcohol, cleanser, or soap or detergents. (ENG) VQT2M30 17 Standard Accessories Standard Accessories Check that all the accessories are included before using the camera. Product numbers correct as of January 2010. These may be subject to change. 1 Battery Pack (Indicated as battery pack or battery in the text) Charge the battery before use. 2 Battery Charger (Indicated as battery charger or charger in the text) 3 USB Connection Cable 4 AV Cable 5 CD-ROM • Software: Use it to install the software to your PC. • Operating Instructions 6 Brush 7 Silicon Jacket 8 Hand Strap 9 Battery Case • Supplied accessories are not waterproof (excluding hand strap/silicon jacket). • Keep the Brush out of reach of children to prevent swallowing. • The charger is stored inside the silicon jacket. • SD Memory Card, SDHC Memory Card and SDXC Memory Card are indicated as card in the text. • The card is optional. You can record or play back pictureson the built-in memory when you are not using a card. • For information about optional accessories, refer to the “Digital Camera Accessory System”. • If any accessories are lost, customers should contact Panasonic’s partsdepartment at 1 800 833-9626 for further information about obtaining replacement parts. DMW-BCF10PP DE-A59B 3 4 VGQ0D56 9 1 2 K1HA14CD...