Selecting the maps to add/remove 1 Check the map(s) that you want to add, and uncheck any map(s) you want to remove. 2 Click . The confirmation display appears. 3 Click “OK.” Addition or removal of the map starts. Notes • The display differs depending on the model, etc. • Addition/removal time differs depending on the computer performance or map type. (For example, it takes approximately 8 hours to transfer the map of Europe A to the navigation unit.) • Due to the nature of the updated, highly-detailed map content, the area may be different from the map data used now. • If you cannot select the map, refer to “Freeing up free space on the navigation unit” (page 5). Completing the map addition/removal Completing the map addition/removal The addition/removal of the map is completed when the above message is displayed. 1 Click “OK.” 2 Click “Exit” to quit the application. For NV-U71T/U51 users: Turn off the navigation unit by the POWER switch on its bottom, and disconnect the cables. Turn on the navigation unit again. For NV-U93T/U92T/U83/U82/U73T/U72T/U53/U52 users: Disconnect the cables to use the navigation unit. Important Q & A 1 Does your “Address Book” and “Home Address” data remain after the update? In many cases this data will remain, however, some data may generate an error message as a result of the updated map data. In this case, you will need to delete the particular “Address Book” and re-register it with the revised map data installed. Prior to updating your navigation unit, please make a note of all “Address Book” for safekeeping. 2 Can previous map data be restored after updating the navigation unit? Cannot be restored to the factory default map of the navigation unit. 3 I cannot set the destination registered in “Address Book.” What should I do? You may have selected a destination out of the range of the selected map. Confirm whether the selected destination is within the range of the selected map data. The destination may not be set even within the range of the selected map, since the map data was updated. If the selected destination is within the range of the selected map, register the destination point again. 4 I cannot use a saved route. What should I do? You may have selected a route out of the range of the selected map. Confirm whether the selected route is within the range of the selected map data. The route may no longer be set within the range of the selected map, since the map data was updated. If the selected route is within the range of the selected map, register the route again. 5 What should be done if a cable gets disconnected during the update process? Cancel the process, reconnect the cable and start over. Hinweise zur...

Ce manuel est également adapté pour les modèles :
navigateurs GPS et des récepteurs - NVD-U13R (876.46 kb)
- ()
- ()