Évaluations - 2, GPA: 4 ( )

Fabricant : Shoprider Taille : 560.56 kb Nom Fichier : Langue d'enseignement:

Battery performance can be affected by temperature, terrain, condition of battery, the weight of the user, etc. The battery level indicator/gauge is only a guide and is most effective when the scooter is in drive, only then is the true battery discharge level displayed. • When the scooter stops the battery level indicator may indicate full (no load on batteries). • An active user can use up to 30% of battery capacity or more per day. • Inactive users may only use 50% of battery capacity in a week. • In both these instances the batteries should be put on charge over night. Battery Charger Batteries required for your scooter are specially designed. All Shoprider® scooters require a Shoprider® automatic battery charger. These chargers have an electronic switch that will terminate the charge when the batteries are fully charged. All Shoprider® chargers rely on a specific minimum feed-back voltage signal from the batteries in order to begin the charging cycle. If the batteries are severely discharged, the charger does not receive the required feed-back signal and the charger will not charge the batteries. Please contact your authorized Shoprider® provider for assistance. The battery charger supplied for the Shoprider® Sprinter XL3 Deluxe, Sprinter XL4 Deluxe, and Sprinter Jumbo XL scooters are 24 volt 8 amp transformer type off-board chargers. The battery charger supplied for the Shoprider® Sprinter XL4 scooter is a 24 volt 3 amp transformer type off-board charger. Charging Charge the batteries completely (8-12 hours) prior to first time use. To charge the batteries connect the plug lead into the battery-charging socket on the scooter tiller and the 3-prong A/C plug into the wall socket and switch on (8 amp charger only). FOR Sprinter XL: the battery charger has two lights. The red light when constant shows the battery charger is connected, if the red light flashes; there is a break in the connection. The green light flashes when the batteries are receiving charge and is constant when the charge is complete. FOR Sprinter XL3 Deluxe, XL4 Deluxe and Jumbo XL: The battery charger has two lights. The red light shows the battery charger is connected and has power (switched on). The second light will show a gold light while charging and a green light when the charge is complete. CAUTION: Always ensure that the charging lead is in good condition and has not been damaged or stretched. MAINTENANCE Lubrication At six-month intervals you should lubricate the following parts with a multipurpose grease or similar lubricant: • Seat pivot post. • Seat release lever pinion. • Clean and recoat axles lightly. CAUTION – DO NOT USE WD40 TO LUBRICATE PARTS!! DO NOT LUBRICATE TRANSAXLE GEARS!! In the event of any difficulties please consult your provider. 12/29/2004 13 Wheels and Tires The wheels of your scooter have split rims. This allows any punctures to be repaired easily. To change the wheel remove the center 13 mm bolt and slide the wheel off its axle. Ensure that when refitting the wheel the retaining bolt is fitted with a locking washer or the screw threads are treated with lock-tite or a similar adhesive. When changing a tire the inner tube must be deflated. Remove the four bolts from the wheel and split the rim. Tire pressure is recommended to be kept at 30 psi on the rear tires, and 25 psi on the front. General Scooter Maintenance Every six months check the tiller base bolts, wheel axle bolts, and arm rest angle adjustment bolts and tighten as necessary. Also check the seat and arm rest tightening knobs and tighten as needed. TROUBLE SHOOTING GUIDE Circuit Breaker Your scooter is fitted with the latest in electronic controls that are programmed to protect the electrical system from abnormal overloads. Fitted for extra protection is a circuit breaker, should there be a situation that your scooter stops for no apparent reason please check that the circuit breaker has not popped out or tripped. The circuit breaker can be found under the rear chassis cover accessible through a port hole under the seat. Check List If your scooter fails to operate, please check the following: • Unit is switched on. • All plugs and connectors are firmly fixed. • Battery level shows full charge. • Freewheeling device is in the drive position (lever down). • Circuit breaker is reset. • Battery fuses are not blown. If the free wheel device has been operated with the scooter switched on, then the scooter will not operate until the ignition key has been switched off and then on again in order to reset the circuits. Please consult your provider if your scooter does not run after checking these points. 12/29/2004 14 TECHNICAL SPECIFICATIONS UNIT SPECIFICATIONS Sprinter XL4 Sprinter XL3 Deluxe Sprinter XL4 Deluxe Sprinter Jumbo XL Overall Dimensions: L. x W x H. in 52 x 23 x 30 51 x 27 x 35 53 x 27 x 34 56 x 25 x 37 Number, Size of Tires Front 2 , 10” 1 , 12” 2 , 12” 2 , 14” Rear 2 , 10” 2 , 12” 2 , 12” 2 , 14” Suggested User Weight (on the level road) l...

Téléchargez votre

Pour télécharger, entrez 2 chiffres :