Évaluations - 4, GPA: 3.8
(
)
)
|
Facilité d'utilisation
Replace them as necessary. • Check the caster forks for damage or fluttering which indicates that they may need to be adjusted or have the bearings replaced. See an authorized Pride Provider for repair. • Keep your Go-Chair clean and free of foreign material, such as mud, dirt, hair, food, drink, etc. Yearly Checks Take your Go-Chair to an authorized Pride Provider for yearly maintenance, especially if you use your chair on a daily basis. This helps ensure that your Go-Chair is functioning properly and helps prevent future complications. 32 Go-Chair VII. CARE AND MAINTENANCE VII. CARE AND MAINTENANCE Storage Your Go-Chair should be stored in a dry place, free from temperature extremes. When storing, disconnect the batteries from the Go-Chair. See VI. “Batteries and Charging.” WARNING! If you fail to store the unit properly, the frame can rust and the electronics can be damaged. Batteries that are regularly and deeply discharged, infrequently charged, stored in extreme temperatures, or stored without a full charge may be permanently damaged, causing unreliable performance and limited service life. It is recommended that you charge the batteries periodically throughout periods of prolonged storage to ensure proper performance. You may wish to place several boards under the frame of your Go-Chair to raise it off of the ground during periods of prolonged storage. This takes the weight off the tires and reduces the possibility of flat spots developing on the areas of the tires contacting the ground. Disposal of Your Go-Chair Your Go-Chair must be disposed of according to applicable local and national statutory regulations. Contact your local waste disposal agency or authorized Pride Provider for information on proper disposal of travel chair packaging, metal frame components, plastic components, electronics, batteries, neoprene, silicone, and polyurethane materials. Cleaning and Disinfection • Use a damp cloth and mild, non-abrasive cleanser to clean the plastic and metal parts of your Go-Chair. Avoid using products that may scratch the surface of your chair. • If necessary, clean your product with an approved disinfectant. Make sure the disinfectant is safe for use on your product before application. WARNING! Follow all safety instructions for the proper use of the disinfectant and/or cleaning agent before applying it to your product. Failure to comply may result in skin irritation or premature deterioration of upholstery and/or travel chair finishes. WARNING! Never hose off your travel chair or place it in direct contact with water. Your travel chair has a painted, ABS plastic body shroud that allows it to be easily wiped clean with a damp cloth. WARNING! Never use any chemicals to clean a vinyl seat, as they may cause the seat to become slippery or dry out and crack. Use soapy water and dry the seat thoroughly. Wheel Replacement If your chair is equipped with a solid tire insert, then you must replace the whole wheel assembly. Replacement wheel assemblies are readily available through an authorized Pride Provider. WARNING! The wheels on your travel chair should only be serviced or replaced by an authorized Pride Provider or a qualified technician. WARNING! Be sure that the power to the controller is turned off and the travel chair is not in freewheel mode before performing this procedure. WARNING! When changing a tire, remove only the center lug nut and washer, then remove the wheel. If any further disassembly is required, deflate the tire completely or it may explode. DRIVE WHEEL WASHER DRIVE WHEEL NUT AXLE KEY Figure 24. Go-Chair Drive Wheel AXLE SLOT Go-Chair 34 Go-Chair Battery Replacement A battery wiring diagram is printed on a decal located on the front battery tray. See the specifications table for correct battery specifications. MANDATORY! Battery posts, terminals, and related accessories contain lead and lead compounds. Wear goggles and gloves when handling batteries and wash hands after handling. WARNING! The batteries in your travel chair should only be serviced or replaced by an authorized Pride Provider or a qualified technician. WARNING! Do not replace the batteries when seat is occupied. WARNING! Travel chair batteries are heavy. See specifications table. If you are unable to lift that much weight, be sure to get help. Use proper lifting techniques and avoid lifting beyond your capacity. WARNING! Do not mix old or new batteries. Always replace both batteries at the same time. Figure 25. Go-Chair Battery Box PROHIBITED! Keep tools and other metal objects away from the battery terminals. Contact with tools can cause electrical shock. You may need the following to change your batteries: .. metric/standard socket set and ratchet .. adjustable wrench To replace the batteries: 1. Remove the battery box from the Go-Chair. 2. Turn the pack upside down. 3. Remove all screws that hold the battery box halves together. See figure 25. 4. Fli...