Évaluations - 3, GPA: 4.3
(
)
)
|
Facilité d'utilisation
1300, 1035965, and 1035966 NOTE: Check all parts for shipping damage and test before using. In case of damage, DO NOT use. Contact the dealer/Invacare for further instructions. SAFETY SUMMARY The following recommendations are made for the safe installation of the Wheelchair Tray: WARNING DO NOT assemble or use this equipment without first reading and understanding this instruction sheet. If you are unable to understand the Warnings, Cautions or Instructions, contact a healthcare professional, dealer or technical personnel if applicable before attempting to install this equipment - otherwise, injury or damage may occur. Any worn or damaged hardware MUST be replaced. After installation, repair or service and BEFORE use, make sure all attaching hardware is securely tightened - otherwise, injury or damage may result. INSTALLING WHEELCHAIR TRAY (FIGURE 1) 1. Remove the two (2) phillips screws from the arm pad. 2. Slide the bracket support tube into the bar guide assembly as shown in FIGURE 1. NOTE: The bracket of the bar guide assembly and the tube of the bracket support should be positioned towards the outside of the wheelchair frame. 3. Loosely install phillips screw through the bracket support tab, wheelchair frame and arm pad. 4. Position the bar guide assembly tab to align with the mounting hole of the wheelchair frame. 5. Loosely install phillips screw through the bar guide assembly, wheelchair frame and arm pad. 6. Repeat STEPS 1-5 for opposite side. 7. Remove protective paper from the tray. 8. Position the tray bracket on the wheelchair tray BOTTOM as shown in FIGURE 1. NOTE: For wheelchairs over 18-inches wide, reverse the tray brackets with the sockets positioned towards the outside of the tray. 9. Install carriage bolts through TOP of wheelchair tray and tray bracket. 10. Secure the tray bracket to the tray with the two (2) wing nuts. 11. Repeat STEPS 8-10 for opposite side. 12. Insert the tray support bar into the tray bracket and hand tighten the socket screw. 13. Insert the tray support bars into the bracket supports at the desired position. 14. Securely tighten the four (4) phillips screws. 15. Center the tray on the wheelchair. NOTE: If the tray will not center, adjust tray support bars. 16. After making sure the tray is centered on the wheelchair, securely tighten the socket screws. Wheelchair Tray Carriage Bolts Wheelchair Tray Frame Bracket Tray Support Bars Bracket Bar Guide Assembly . Socket Screw ^ Wing Nuts Tab Bracket Support and Tube Phillips Screws FIGURE 1 - INSTALLING WHEELCHAIR TRAY Invacare Corporation One Invacare Way Technical Support Invacare is a registered trademark of Invacare Corporation Elyria, Ohio USA 800-832-4707 ©1999 Invacare Corporation 44036-2125 800-333-6900 Form No. 84-41 P/N 1023704 Rev. B (1) - 11/99...
Ce manuel est également adapté pour les modèles :Fauteuils roulants - 1035966 (38.35 kb)