Évaluations - 2, GPA: 4.5 ( )

Fabricant : HP Taille : 210.14 kb Nom Fichier : Langue d'enseignement:

Some HP Surge Protector models can protect your telephone, DSL, modem, video, coaxial, and networking equipment. NOTE: Telephone, DSL, and modem protection is not included with model number 2160. Video/Coaxial Protection is not included with model number 1620. A Power cord — a 14-gauge heavy duty cord that provides input power from the wall outlet to the surge-protected outlets. The cord has a 360-degree rotating plug to prevent blocking other outlets and to extend the life of the power cord. B Power switch — integrates with a 15-amp circuit breaker to protect against overloads. To reset the circuit breaker, you must turn the switch off and then on. C Green ground indicator — indicates that your electrical wiring is properly grounded. D Red surge protector indicator — indicates that the surge protection is functioning properly. E Surge-protected outlets — helps protect any connected equipment from power surges and spikes. F Sliding safety covers — helps protect users and children from accidental contact and keeps dust away from unused outlets. G Telephone/fax/modem/DSL protection — helps protect your telephone, fax, modem, and DSL lines from surges and spikes. • One telephone wall connector (labeled In) — connects an RJ-11 telephone line from the wall to the HP Surge Protector. • Two telephone/modem/fax connectors (labeled Out) — connects two RF-11 telephone cables from the HP Surge Protector to a telephone line, fax line, modem, or DSL. H Network protection — helps protect your networking equipment from surges and spikes. I Video/coaxial protection — helps protect your cable modem, TV, and VCR from power surges and spikes. The input connector is used to connect a standard RG-6U cable TV input coaxial cable to the HP Surge Protector. Using Your HP Surge Protector You can begin using your HP Surge Protector in a few easy steps. 1 Place your HP Surge Protector in a dry, cool place away from heat-emitting appliances. 2 Connect the cabling directly to the telephone, CATV, and other equipment to be protected, and then verify the system is working properly. 3 Connect the equipment to the HP Surge Protector (E, G, H, I). Make sure all of the plugs are fully inserted before plugging the HP Surge Protector into the wall. 4 Connect the AC power cord (A) to a wall outlet. 5 Turn the power switch to the On position (B). 6 Check that the green LED (C) is lit, indicating your HP Surge Protector is properly grounded. 7 Check that the red LED (D) is lit, indicating your HP Surge Protector is operating properly. Using the Cord Management System (Select models only) The cord management cover keeps all cords neat and organized. To use the cord management system: 1 Slide the cord management cover away from the HP Surge Protector. 2 Place the cords through the back opening by pressing them through the middle of the cord management cover. Francais Les garanties des produits et services Hewlett-Packard sont exclusivement presentees dans les declarations expresses de ga...

Téléchargez votre

Pour télécharger, entrez 2 chiffres :