Évaluations - 1, GPA: 4 ( )

Fabricant : AEG Taille : 605.35 kb Nom Fichier : 947165en.pdf Langue d'enseignement:

2. Pull the base of the side rail forwards and unhook at the top. 3. To refit, insert the side rail at the top and place against the side of the oven. 4. Re-fit the bolt. Operating Instructions Oven Light Bulb 1 Warning: Before changing the light bulb in the oven: – Switch off the oven! – Isolate the oven from the power supply. Replacing the Light Bulb in the Oven/Cleaning the Glass. 0 1. Place a cloth on the floor of the oven. 2. Remove the glass cover and clean. 3. Oven lighting, replace with a 25 Watt, 230 V, 300 °C heat resistant bulb. 4. Refit the glass cover. 5. Remove the cloth from the oven. Operating Instructions Catalytic oven ceiling The oven has a catalytic oven ceiling. Catalytic liners are self cleaning and will destroy splashes of food and fats while the oven is on. To aid this process and to ensure continued good performance of the liners, we recommend you run the oven, without food, once a week. 0 1. Empty the oven including the wire shelf support grids. 2. Set the temperature at 250 °C. 3. Switch off the oven after 1 hour. 1 Attention: Manual cleaning of the catalytic liners is not recommended! Damage will occur if oven sprays or abrasives of any kind are used. 3 Slight discolouration of the catalytic surfaces may occur in time. This does not affect the catalytic properties in any way. Additonal and replacement catalytic panels are available as an optional extra. Please refer to the chapter “Special accessories“. Assembly 1 Important: The surface of the catalysis sheets is prone to scratches! Important: The grill heater element must not be folded down using force. There is a risk it may be broken! Operating Instructions 42 1. 2. 3. Operating Instructions Oven Door The oven door on your appliance can be removed for cleaning. Removing the Oven Door 0 1. Open the oven door completely. 2. Lift up fully the coloured clamping lever on both door hinges (1). 3. Close the oven door around 3/4 of the way, overcoming the resistance (2). 4. Take hold of the side of the oven door with both hands. Lift the door upwards (Caution: heavy!) and remove from the oven (3). 5. Place the door, with the outer surface downwards, on a soft, flat surface, for example a blanket, to avoid scratches. Hanging the Oven Door 0 1. Take hold of the sides of the door with both hands from the handle side. 2. Hold the door at an angle of approx. 60°. 3. Slide the door hinges as far as possible into the two cut-outs on the right and left on the bottom of the oven (1). 4. Lift the door up until resistance is met and then open fully (2). 5. Turn the clamping levers on both door hinges back into their original position (3), so that the coloured marks again point upwards. 6. Close the oven door. Operating Instructions Oven Door Glass The oven door is fitted with two panes of glass, these are fitted one behind the other. The inner pane can be removed for cleaning. 1 Warning: Please only perform the following steps on the oven door when it has been removed from the oven! When the door is fitted, the reduction in the weight of the door when the glass is removed could lead to the door suddenly closing and creating a hazard. Removing the Door Inner Glass 0 1. Remove the oven door and place on a soft, level surface with the handle downwards. 2. Take hold of the pane of glass at the upper edge and slide it against the spring pressure in the direction of the oven door handle until it is free at the base (1). 3. Lift the pane gently at the base and remove (2). Replacing the Inner Door Glass 0 1. Guide the pane of glass at an angle from above into the door section on the handle side (1). 2. Lower the pane of glass (2). Place the pane, against the force of the spring on handle side, in front of the retaining section on the lower edge of the door and slide it under the retaining section. The pane of glass must sit securely! 3. Refit the oven door. Operating Instructions What to do if ... .... the oven does not heat up? 0 Check whether – the appliance is switched on – the time is set, – all the necessary settings have been made, – the mains fuse (fuse box) has blown. If the fuse blows several times, please call an electrician. .... the oven lighting ceases to function? 0 Replace the oven light bulb (see Cleaning and Care). If you call in an engineer to resolve a problem listed in these notes, or due to an operating error, the customer service engineer’s visit is not cost free, even during the warranty period. If this information does provide you with the necessary assistance, please seek specialist advice. 1 Warning: Repairs to the appliance must be carried out by qualified service engineers! Improper repairs can give rise to significant hazards for the user. If your appliance needs repairing, please contact your local AEG Service Force Centre. Service & Spare parts SERVICE & SPARE PARTS If you wish to purchase spare parts or require an engineer, contact your local AEG Service Force Centre by telephoning: 08705 929 929 Your telephone call will ...

Téléchargez votre

Pour télécharger, entrez 2 chiffres :