Évaluations - 0, GPA: 0 ( )

Fabricant : Philips Taille : 7.66 mb Nom Fichier : Langue d'enseignement:

English 10 EnglisH 3 Lubricate the trimmer teeth with a drop of sewing machine oil every six months. storage Put the protection cap on the shaver to prevent damage to the shaving heads. replacement Replace the shaving heads every two years for optimal shaving results. Replace damaged or worn shaving heads with HQ8 Philips shaving heads only. Note: Do not mix up the cutters and the guards to guarantee optimal shaving performance. 1 Switch off the shaver, remove the powerplug from the wall socket and pull the appliance plug out of the shaver. 2 Press the release button to open the shaving unit. 3 Turn the lock anticlockwise (1) and remove the retaining frame (2). , , EnglisH 11 4 Remove the shaving heads and place new ones in the shaving unit. Put the retaining frame back into the shaving unit and turn the lock clockwise. Make sure that the projections of the shaving heads fit exactly into the recesses. 5 Close the shaving unit. Accessories The following accessories are available: HQ8500/HQ8000 powerplug. HQ8 Philips Shaving Heads. HQ110 Philips Shaving Head Cleaning Spray. HQ8010 car cord. Environment Do not throw away the appliance with the normal household waste at the end of its life, but hand it in at an official collection point for recycling. By doing this, you help to preser ve the environment. Disposal of the battery The built-in rechargeable NiMH batter y contains substances that may pollute the environment. Always remove the batter y before you discard and hand in the appliance at an official collection point. Dispose of the batter y at an official collection point for batteries. If you have trouble removing the batter y, you can also take the appliance to a Philips ser vice centre.The staff of this centre will remove the batter y for you and will dispose of it in an environmentally safe way. ---- - Only remove the battery if it is completely empty. 1 Remove the powerplug from the wall socket and pull the appliance plug out of the shaver. 2 Let the shaver run until it stops, undo the two screws in the hair chamber by means of a screwdriver and remove it. 3 Undo the four screws at the front of the shaver by means of a hexagon key and remove the front panel of the housing. 4 Remove the side panels by pulling them off the sealed power unit. 5 Remove the back panel of the housing. 6 Undo the three screws in the sealed power unit by means of a screwdriver on the back of the shaver. 7 Remove the back panel of the sealed power unit by means of a screwdriver. 8 Remove the battery. Be careful, the battery strips are very sharp. Do not connect the shaver to the mains again after the battery has been removed. 12 English EnglisH 13 Guarantee & service Troubleshooting If you need information or if you have a problem, please visit the Philips website at or contact the Philips Customer Care Centre in your countr y (you find its phone number in the worldwide guarantee leaflet). If there is no Customer Care Centre in your countr y, go to ...

Téléchargez votre

Pour télécharger, entrez 2 chiffres :