|
Facilité d'utilisation
-The powerplug contains a transformer. Do not cut off the powerplug to replace it with another plug, as this causes a hazardous situation. -Do not use a damaged powerplug. -If the powerplug is damaged, always have it replaced with one of the original type in order to avoid a hazard. -Make sure the powerplug does not get wet. -Charge and store the shaver at a temperature between 5°C and 35°C. -Always unplug the shaver before cleaning it under the tap. -The appliance complies with the internationally approved IEC safety regulations and can be safely cleaned under the tap. Be careful with hot water. Always check if the water is not too hot, to prevent your hands from getting burnt. -This washable shaver is not suitable for shaving in the shower. EnglisH Do not immerse the shaver in water. Water may leak from the socket at the bottom of the appliance when you rinse it.This is normal and not dangerous because all electronics are enclosed in a sealed power unit inside the shaver. To extend the lifetime of the batter y: do not charge the shaver for more than 12 hours. only charge the shaver when the batter y-low light goes on. Electromagnetic fields (EMF) This Philips appliance complies with all standards regarding electromagnetic fields (EMF). If handled properly and according to the instructions in this user manual, the appliance is safe to use based on scientific evidence available today. charging Make sure the appliance is switched off before you star t to charge it. Charging takes approx. 8 hours. To extend the lifetime of the batter y, do not charge the shaver for more than 12 hours. - - -- 6 EnglisH Charge indications charging When you start charging the empty shaver, the charging light goes on. Battery running low When the battery is running low, the battery-low light goes on. When you switch off the shaver, this light flashes a few times. Cordless shaving time After charging, the shaver has a cordless shaving time of up to 30 minutes. charging the appliance Only charge the shaver when the battery-low light goes on. Put the appliance plug in the shaver. Put the powerplug in the wall socket. Remove the powerplug from the wall socket and pull the appliance plug out of the shaver when the battery has been fully charged (after approx. 8 hours). Using the appliance , , 1 2 3 The shaver cannot be used directly from the mains. EnglisH Shaving 1 Press the on/off button once to switch on the shaver. The power-on lights go on to indicate that the motor is running. 2 Move the shaving heads quickly over your skin, making both straight and circular movements. -Shaving on a dr y face gives the best results. -Your skin may need 2 or 3 weeks to get accustomed to the Philips shaving system. 3 Press the on/off button once to switch off the shaver. The power-on lights go out. 4 Clean the shaver (see chapter ‘Cleaning and maintenance’). 5 Put the protection cap on the shaver every time you have used it, to prevent damage to the shaving heads. trimming For grooming sideburns and moustache. 1 Open the trimmer by pushing the slide downwards. The trimmer can be activated while the motor is running. 2 Close the trimmer (‘click’). 8 EnglisH Cleaning and maintenance Regular cleaning guarantees better shaving performance. Be careful with hot water. Always check if the water is not too hot, to prevent your hands from getting burnt. Note:Water may leak from the socket at the bottom of the appliance when you rinse it.This is normal and not dangerous. Every day: shaving unit and hair chamber 1 Switch off the shaver. 2 Press the release button to open the shaving unit. 3 Clean the shaving unit and the hair chamber by rinsing them under a hot tap for some time. Make sure you clean the inside as well as the outside of the shaving unit. 4 Close the shaving unit and shake off excess water. Never dry the shaving unit with a towel or tissue, as this may damage the shaving heads. , 5 Open the shaving unit again and leave it open to let the appliance dry completely. You can also clean the hair chamber without water by using the brush supplied. Every six months: shaving heads 1 Open the shaving unit, turn the lock anticlockwise (1) and remove the retaining frame (2). 2 Clean the cutters and guards with the brush supplied. Do not clean more than one cutter and guard at a time, since they are all matching sets. If you accidentally mix up the cutters and guards, it may take several weeks before optimal shaving performance is restored. 3 Put the shaving heads back into the shaving unit. Put the retaining frame back into the shaving unit and turn the lock clockwise. 4 Close the shaving unit. Trimmer Clean the trimmer every time you have used it. 1 Switch off the shaver. English 10 EnglisH 2 Clean the trimmer with the brush supplied. 3 Lubricate the trimmer teeth with a drop of sewing machine oil every six months. storage Put the protection cap on the shaver to prevent damage to the shaving heads. replacement Replace the shaving heads every two years fo...
Ce manuel est également adapté pour les modèles :électrique - HQ7120/17 (4.43 mb)