In normal use: 1. Turn the AC circuit breaker to the OFF position. 2. Disconnect all electrical loads from panel receptacles. Disconnect DC battery charging cables. 3. Turn the engine switch to the OFF position. 4. Turn the fuel valve to the OFF position. MAINTENENCE Periodic maintenance and adjustment is necessary to keep the generator in good operating condition. Perform the service and inspection at the intervals shown in the Maintenance schedule below. Exhaust gas contains poisonous carbon m

This manual contains the information on how to do that; please read it carefully. This owner’s manual describes the operation and maintenance of the Generator. All information in this publication is based on the latest product information available at the time of printing. We reserve the right to make changes at any time without notice and without incurring any obligation. No part of this publication may be reproduced without written permission. This manual should be considered a permanent part

Engine serial number: 6 CONTROLS Engine Switch To start and stop the engine. Switch position: OFF: To Stop the engine. Key can be removed/inserted. ON: To run the engine after starting. START: To start the engine by turning the starter motor. Return the key to the ON position once the engine has started. Do not use the starter for more than 5 seconds at a time. If the engine fails to start, release the switch and wait 10 seconds before operating the starter again. Recoil Starter To start the eng

Bar, 2 HP 1100 1100 Electric Welder: 200 Amp AC 9000 9000 Electric Welder: 230 Amp AC at 100 Amp 7800 7800 High-pressure Washer (1 HP) 3600 1200 Mitre Saw 2400 1650 Power drill 1500 500 Power hand sander 1500 500 Power hand saw 1800 600 Pressure Washer (1 HP) 3600 1200 Table Saw (10") 4500 1800 Well & Sump Pumps Surge Wattage (Startup) Running Wattage Sump Pump: 1/3 HP 1300 800 Sump Pump: 1/2 HP 2150 1050 Well Pump: 1/3 HP 2000 1000 24 Limited Warranty Queen Bee Power™ Generators are warranted b

4. Connect the negative (-) battery cable to the battery negative (-) terminal. 5. Connect the other end of the negative (-) battery cable to the generator negative (-) terminal. 6. Start the generator. NOTICE Do not start the vehicle while the battery charging cables are connected and the generator is running. The vehicle or the generator may be damaged. An overloaded DC circuit, excessive current draw by the battery, or wiring problem will trip the DC circuit protector (PUSH button extends out