Évaluations - 4, GPA: 4
(
)
)
|
Facilité d'utilisation
.1 Kit Preparation....................................... .2 Kit Assembly - Double DIN Radio Provision ... ............................ .3 -Stacked ISO Mount Units Provision .......................... 3 Final Assembly ...........................................4 *Note: Refer also to the instructions included with the aftermarket radio. 95-8224 DASH DISASSEMBLY Toyota Matrix/Pontiac Vibe 2009-10 1 Disconnect the negative battery terminal to prevent an accidental short circuit. 2 Unclip and remove the radio trim panel including the a/c vent. (Figure A) 3 Remove (4) 10 MM bolts securing the radio. Unplug and remove the radio. (Figure B) Continue to kit preparation. A B 1 95-8224 KIT PREPARATION DOUBLE DIN RADIO PROVISION STACKED ISO MOUNT UNITS *Note: Refer also to the instructions included with the aftermarket radio. 1 Snap the Double DIN Trim plate into the rear of the factory radio trim panel. (Figure A) Continue to kit assembly. A 2 95-8224 KIT ASSEMBLY DOUBLE DIN RADIO PROVISION STACKED ISO MOUNT UNITS PROVISION *Note: Refer also to the instructions included with the aftermarket radio. 1 Attach the Double DIN brackets to the Double DIN or the stacked ISO mount unit(s) using the screws supplied with the unit(s). (Figure A) Continue to final assembly. A 3 95-8224 FINAL ASSEMBLY FINAL ASSEMBLY (A) Strip wire ends back 1/2" B) Twist ends together C) Solder D) Tape 1 Locate the factory wiring harness in the dash. Metra recommends using the proper mating adapter and making connections as shown. (Isolate and individually tape off the ends of any unused wires to prevent electrical short circuit.) 2 Re-connect the negative battery terminal and test the unit for proper operation. 3 Reassemble radio and dash assemblies in reverse order of disassembly. FINAL WIRING CONNECTIONS Make wiring connections using the EIA color code chart shown below and the instructions included with the head unit. Metra recommends making connections as shown below; Strip, Splice, Solder, Tape. Isolate and individually tape off ends of any unused wires to prevent electrical short circuit. METRA / EIA WIRING CODE 12V Ignition / Acc...... . . . . Red Right Front (+) ...... ......Gray 12V Batt / Memory..... . . . . Yellow Right Front (-)....... ......Gray/ Black Ground.............. . . . . Black* Left Front (+) ....... ......White Power Antenna........ . . . . Blue Left Front (-)........ ......White / Black Amp Turn-On ......... . . . . Blue / White Right Rear (+) ...... ......Violet Amp Ground.......... .... Black / White Right Rear (-) ....... ......Violet / Black Illumination .......... .. . . Orange Left Rear (+) ....... ......Green Dimmer ............. . . . . Orange / White Left Rear (-)........ ......Green / Black *NOTE: When a Black wire is not present, ground radio to vehicle chassis. All colors may not be present on all leads due to manufacturer's specifications. 4 () B C CJ-. ) D B V- Kill -J 95-8224 NOTES 5 95-8224 INSTRUCTIONS 3 1-800-221-0932 Q REV. 04/27/10 ©COPYRIGHT 2004-2010 METRA ELECTRONICS CORPORATION INST95-8224...