Évaluations - 4, GPA: 4 ( )

Fabricant : Louisville Tin and Stove Taille : 291.64 kb Nom Fichier : 66230cbf-6cf4-40f6-8074-ed23fd3bc06a.pdf Langue d'enseignement:

THIS UNIT IS NOT TO BE INSTALLED IN MOBILE HOMES. WARNING: If the information in this manual is not followed exactly, a fire or explosion may result causing property damage, personal injury or loss of life. -Do not store or use gasoline or other flammable vapors and liquids in the vicinity of this or any other appliance. -WHAT TO DO IF YOU SMELL GAS: • Do not try to light any appliance. • Do not touch any electrical switch; do not use any phone in your building. • Immediately call your gas supplier from a neighbor’s phone. Follow the gas supplier’s instructions. • If you cannot reach your gas supplier, call the fire department. -INSTALLATION AND SERVICE MUST BE PERFORMED BY A QUALIFIED INSTALLER, SERVICE AGENCY OR THE GAS SUPPLIER. WARNING: Operation of this heater when not connected to a properly installed and maintained venting system or tampering with the vent safety shut-off system can result in Carbon Monoxide (CO) poisoning and possible death. RADIANT FRONT CLOSED FRONT This unit is not approved for installation in mobile homes, greenhouses, or environments involving dusty, wet, corrosive, or explosive conditions. Such conditions will invalidate the warranty and may create unsafe conditions. The coating selected to provide longer life to the heat exchanger may smoke slightly upon initial firing. Provide adequate ventilation if this occurs. NATURAL GAS VC201A-H VC351A-H VC501A-H VC701A-H VCR351A-H VCR501A-H VCR701A-H PROPANE GAS VC202A-H VC352A-H VC502A-H VC702A-H VCR352A-H VCR502A-H VCR702A-H TABLE OF CONTENTS SPECIFICATIONS………………………. 2 RADIANTS & GLASS PANELS……….. 8 INTRODUCTION……………………….. 3 BURNER ORIFICE & ORIFICE CHART.......... 8 VENTING………………………………... GAS SUPPLY……………………………. 3 ,4 5 PROPER BURNER FLAME.............…………. 9 MAINTENANCE…………………………....... 9 LOCATION & SPECIAL PRECAUTIONS 5 LIGHTING INSTRUCTIONS……………........ 10 COMBUSTION & VENTILATION AIR.... 6 TROUBLE SHOOTING CHART………… 11,12 CLEARANCES………………………….. 7 BLOWER INSTRUCTIONS……………… 13 DRAFT DIVERTER…………………….. 7 TSK WALL STAT KIT................................ 14 DOOR KNOB…………………………… 7 PARTS DRAWING……………………….. 15 PILOT ADJUSTMENT…………………. 8 PARTS PRICE LIST………………………. 16 WARRANTY……………………………… 18 READ CAREFULLY BEFORE INSTALLING UNIT These installation instructions are a general guide and do not supersede applicable local codes and ordinances. Before planning or making the installation be sure it complies with all phases of the local heating code. (Or, in the absence of local codes, with the latest edition of National Fuel Gas Code, ANSI.Z223.1, or CAN1-B149). The appliance, when installed, must be electrically grounded in accordance with local codes, or in the absence of local codes, with the latest edition of National Electrical Code ANSI/NFPA 70, or Canadian Electrical Code CSA-C22.1. All of the ANSI and NFPA standards referred to in these installation instructions are the ones that were applicable at the time the design of this appliance was certified. The ANSI standards are available from the American Gas Association, 1515 Wilson Blvd., Arlington, VA. 22209. The NFPA standards are available from the national Fire Protection Association, 60 Batterymarch Street, Boston, Massachusetts 02110. Canadian standards are available from International Approval Services, 178 Rexdale Boulevard, Etobicoke, Ontario, Canada M9W 1R3. The design of this appliance was certified to comply with ANSI Z21.11.1 vented room heaters and CAN1-2.1-M86. Installer must leave these instructions with the consumer, have them complete, and return the warranty card....

Téléchargez votre

Pour télécharger, entrez 2 chiffres :