Évaluations - 2, GPA: 4
(
)
)
|
Facilité d'utilisation
.1 KitAssembly -Double DIN Radio Provision .......................................2 -Stacked ISO Mount Units Provision .................................3 FinalAssembly ..........................................4 *Note: Refer also to the instructions included with the aftermarket radio. KNOWLEDGE IS POWER Enhance your installation and fabrication skills by enrolling in the most recognized and respected mobile electronics school in our industry. Log onto or call 800-354-6782 for more information and take steps toward a better tomorrow. 95-7953 DASH DISASSEMBLY SUZUKI GRAND VITARA 2006-2010 A B 1 Disconnect the negative batteryterminal to prevent an accidental short circuit. 1 Unclip and remove the (2) outside trim panels. (Figure A) 2 Remove (6) Phillips screws securing the radio and climate controls to the sub dash. Unplug and remove radio/climate control assembly. (Figure B) 3 Remove the (2) Phillips screws securing the factory radio bracket to the radio/climate control assembly. (Figure C) 4 5 Separate the bracket and factory radio from the climate control. (Figure D) Continue to kit assembly. D C *Note: Refer also to the instructions included with the aftermarket radio. 95-7953 KIT ASSEMBLY DOUBLE DIN RADIO PROVISION *Note: Refer also to the instructions included with the aftermarket radio. NOTE: Mount the radio housing to the climate control assembly using the factory screws removed in step 4 of dash disassembly. 1 Snap the Double DIN brackets to the inside edge of the Double DIN trim plate. (Figure A) 2 Slide the Double DIN radio into the bracket/trim plate assembly and secure the radio to the assembly using the screws supplied with the radio. (Figure B) 3 Snap the Double DIN trim plate onto the front of the housing/radio assembly. (Figure B) Continue to final assembly. 2 A B 95-7953 KIT ASSEMBLY STACKED ISO MOUNT UNITS PROVISION *Note: Refer also to the instructions included with the aftermarket radio. NOTE: Mount the radio housing to the climate control assembly using the factory screws removed in step 4 of dash disassembly. 1 Snap the Double DIN brackets to the inside edge of the Double DIN trim plate. (Figure A) 2 Slide the stacked ISO units into the bracket/radio housing assembly and secure the units to the kit using the screws supplied with the units. (Figure B) 3 Snap the Double DIN trim plate onto the front of the housing/radio assembly. (Figure B) Continue to final assembly. 3 A B 95-7953 FINAL ASSEMBLY FINAL ASSEMBLY (A) Strip wire ends back 1/2" B) Twist ends together C) Solder D) Tape 1 Locate the factory wiring harness in the dash. Metra recommends using the proper mating adapter and making connections as shown. (Isolate and individually tape off the ends of any unused wires to prevent electrical short circuit.) 2 Re-connect the negative battery terminal and test the unit for proper operation. 3 Reassemble radio and dash assemblies in reverse order of disassembly. FINAL WIRING CONNECTIONS Make wiring connections using the EIA color code chart shown below and the instructions included with the head unit. Metra recommends making connections as shown below; Strip, Splice, Solder, Tape. Isolate and individually tape off ends of any unused wires to prevent electrical short circuit. ABCD METRA / EIA WIRING CODE 12V Ignition / Acc. . . . . . . . . . Red 12V Batt / Memory. . . . . . . . . Yellow Ground. . . . . . . . . . . . . . . . . . Black* Power Antenna. . . . . . . . . . . . Blue Amp Turn-On . . . . . . . . . . . . . Blue / White Amp Ground. . . . . . . . . . . . . . Black / White Illumination . . . . . . . . . . . . . . Orange Dimmer . . . . . . . . . . . . . . . . . Orange / White Right Front (+) . . . . . . . . . . . . Gray Right Front (-). . . . . . . . . . . . . Gray/ Black Left Front (+) . . . . . . . . . . . . . White Left Front (-). . . . . . . . . . . . . . White / Black Right Rear (+) ............Violet Right Rear (-). . . . . . . . . . . . . Violet / Black Left Rear (+) . . . . . . . . . . . . . Green Left Rear (-). . . . . . . . . . . . . . Green / Black *NOTE: When a Black wire is not present, ground radio to vehicle chassis. All colors may not be present on all leads due to manufacturer’s specifications. 4 95-7953 NOTES 5 95-7953 INSTRUCTIONS 1-800-221-0932 www.metraonline...