Évaluations - 3, GPA: 4.3 ( )

Fabricant : Mr. Heater Taille : 167.11 kb Nom Fichier : Langue d'enseignement:

Inspect hose assembly before each use of the heater. If there is excessive abrasion or wear, or hose is cut, replace with hose assembly listed on parts list before using heater. 8. For indoor use only. Area must be well ventilated. Figure 1. (also see "Operating Precautions"). 9. If at any time gas odor is detected, IMMEDIATELY DISCONTINUE operation until the source of gas has been located and corrected. Read enclosed Odor fade and Propane Sheet for additional information about detecting propane leaks. 10. Install the heater such that is is not directly exposed to water spray, rain and/or dripping water. 11. Maintain minimum clearance from normal combustible material (like paper). Figure 2. 12. Due to the high surface and exhaust temperatures, adults and children must observe clearances to avoid burns or clothing ignition. 13. Operate only on a stable, level surface. 14. Do not use with ductwork. Do not restrict inlet or exit. 15. Use only the electrical power specified. The electrical connection and grounding must comply with National Electrical Code - ANSI/NFPA 70 (USA) and CSA C22.1 Canadian Electrical Code, Part 1 (Canada). 16. Use only a properly grounded 3-prong receptacle or extension cord. 17. Do not move, handle or service while hot or burning. 18. Do not adjust the heater combustion tube elevation while heater is running or hot. Adjustments to elevation should only be made after the heater has cooled to touch. 19. Use only in accordance with local codes or, in the absence of local codes, with the Standard for the Storage and Handling of Liquefied Petroleum Gases ANSI/NFPA 58 and CSA B149.1, Natural Gas and Propane Installation Code. Figure 1 VENTILATION: Minimum openings required Opening Opening Heater near floor near ceiling Forced air (55) ..................... 1 ft2 ............................................ 1 ft2 Forced air (85, 125) ............. 2 ft2 ............................................ 2 ft2 Figure 2 MINIMUM CLEARANCE: From normal combustible material Clearance 55, 85, 125 Forced Air From floor .......................................... 0 ft From outlet ........................................ 6 ft From sides.......................................... 2 ft From top ............................................ 3 ft Locate 10 ft. from canvas or plastic tarpaulins or similar coverings and secure them to prevent flapping or movement due to wind action. Enerco Group, Inc.| Forced Air Propane Construction Heater 4 Operating Instructions and Owner’s Manual 70056 Rev. C 4/07 ODOR FADE WARNING WARNING Asphyxiation Hazard • Do not use this heater for heating human living quarters. • Do not use in unventilated areas. • The flow of combustion and ventilation air must not be obstructed. • Proper ventilation air must be provided to support the combustion air requirements of the heater being used. • Refer to the specification section of the heater’s manual, heater dataplate, or contact the factory to determine combustion air ventilation requirements of the heater. • Lack of proper ventilation air will lead to improper combustion. • Improper combustion can lead to carbon monoxide poisoning leading to serious injury or death. Symptom of carbon monoxide poisoning can include headaches, dizziness and difficulty in breathing. FUEL GAS ODOR LP gas and natural gas have man-made odorants added specifically for detection of fuel gas leaks. If a gas leak occurs you should be able to smell the fuel gas. Since Propane (LP) is heavier than air you should smell for the gas odor low to the floor. ANY GAS ODOR IS YOUR SIGNAL TO GO INTO IMMEDIATE ACTION! • Do not take any action that could ignite the fuel gas. Do not operate any electrical switches. Do not pull any power supply or extension cords. Do not light matches or ...

Téléchargez votre

Pour télécharger, entrez 2 chiffres :