Log:
Évaluations - 3, GPA: 3 ( )

Instructions Gas-Fired Products, Modèle 3097

Fabricant : Gas-Fired Products
Taille : 368.47 kb
Nom Fichier :
Langue d'enseignement: en
Aller à la télécharger



Facilité d'utilisation


Allow surface to cool before touching. 13. Carefully supervise young children when they are in the room with the heater. 14. Do not use the heater if any part has been exposed to or under water. Immediately call a qualified service technician to inspect the room heater and to replace any part of the control system and any gas control which has been under water. 15. DO NOT operate the heater if any log is broken or damaged. 16. Turn heater off and let cool before servicing. Only a qualified service person should service and repair heater. 17. DO NOT operate this appliance with the safety screen removed. If the safety screen is removed from the appliance for service or cleaning, it must be replaced before operating the heater. High Altitude Derating Input ratings are shown in BTU per hour and are for elevations up to 4,500 feet (1370m). For elevations above 4,500 feet (1370m) consult local building codes. Nuisance outages may occur at altitudes above 4,500 feet (1370m) if dirt, dust, lint and/or cobwebs are allowed to accumulate on burner and/or ODS pilot. Monthly inspection and cleaning is recommended for altitudes above 4,500 feet (1370m). Vermont Castings Jefferson Vent Free Gas Heater General Information Vent Free Features Unpack the Stove The JUVS Gas Heater is an unvented gas appliance tested and listed to the ANSI standard Z21.11.2.2000. The Vent Free Gas Heater is configured to use Natural Gas, (JUVSRN, JUVSMN ) or Propane (JUVSRP, JUVSMP). Because these heaters are clean-burning and highly energy-efficient, no venting system is required. The JUVS is shipped fully assembled with the exception of the log set. The log set is assembled during installation. The JUVS is equipped with a Honeywell control valve that allows thermostatic control, on/off switch or a remote switch (not supplied). The JUVS model incorporates variable regulators that allow you to adjust burner heat output between HIGH, (28,000 BTU), and LOW, (20,000 BTU). See the Operation Section for details. The standing pilot incorporates an Oxygen Depletion System (ODS/pilot) which shuts off gas flow to the burner in the event that sufficient fresh air becomes unavailable for continued safe operation. PILOTADJ Safety Screen Supply Line Inlet OFF/ON/Pilot Control Knob Variable Regulator Gas Valve Piezo Ignitor ST100 Rear Log Bracket Pilot Hood & Pilot Rheostat Bracket Fig. 2 JUVS gas heater. Valve may be different. Remove the stove assembly from the shipping carton and inspect it for loose or damaged parts. Do not install this appliance if any parts are loose or if there is any visual or suspected damage resulting from shipping or handling. Report damage to your dealer/distributor immediately. The log set is packaged in the box shipped inside the firebox. To remove the packaged log set from the firebox: • Lift the stove front up and then swing the bottom out and away to disengage it from the stove body. (Fig. 3) Cut the wire tie securing the screen. • Remove the screen frame. (Fig. 4...

Ce manuel est également adapté pour les modèles :
électrique - 3105 (368.47 kb)
électrique - 3095 (368.47 kb)
électrique - 3096 (368.47 kb)
électrique - 3095 (368.47 kb)

Écrivez votre propre critique du dispositif



Texte du message
Votre nom :
Entrez les deux chiffres :
capcha





catégories